Recommended Method of Attaching Marine Grade Carpet # FCR8008 To Trailer Bunks

Question

Question:

How attach to bunks?

asked by: Robert S

0

Expert Reply:

From my research, it seems that a combination stapling the carpet to the bunks using stainless or Monel (primarily an alloy of copper and nickel) staples and outdoor carpet adhesive is the preferred method of attaching carpet.

I replaced the bunks on my PWC trailer with new pressure-treated 2x4s and the Fulton marine grade carpeting you mentioned. I used stainless staples on the underside of the bunks along with a thin bead of Liquid nails on the top and sides of the boards. I replaced the boards and carpet about 2 years ago, and everything is still holding up very well.

When placing the adhesive on the bunks, keep in mind that some day you might need to replace the carpet, so do not go too heavy on it.

expert reply by: Mike L

0

Answer 1

The 60/40 rule is a great guideline for setting up axle placement on a trailer. But in reality the goal is to place the axles where the trailer will have 10-15 percent of the total trailer weight as tongue weight. The distance you would need to…

view full answer...

Answer 2

I can understand that if your boat is loaded on the trailer, you don't want to remove one of the wheels to measure the fenders. Measuring a fender with the tire still mounted can be tricky, but it's not impossible. I've…

view full answer...

Answer 3

Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Recommended Method of Attaching Marine Grade Carpet # FCR8008 To Trailer Bunks

Product Page this Question was Asked From

Continue Researching