Solera RV Slide-Out Awning Recommendations

Question

Question:

I have a slide that measures 116 inches outside flange to flange do i use a solero 10 foot or 10 foot 6 inch topper the gutter rail on the reflection is 120 inches long

asked by: Bill S

1

Helpful Expert Reply:

For an RV with a slide that measures 116" from flange to flange on the outside of RV, you will want to order the 10-1/2' awning, # LCV000182037 for black or # LCV000163293 for white. This will provide you with and actual awning fabric (when fully extended) that is 121" wide providing 2-1/2" of overhang each side; which is the minimum suggested length.

Please see the attached review and installation videos.

expert reply by: Michael R

1

Answer 1

Based on your slide out measuring 118 inches like you mentioned the correct slide out awning is the part #LCV000163293 that you referenced.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have…

view full answer...

Answer 4

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 5

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 6

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 7

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 8

I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I am…

view full answer...

Answer 9

I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65 ft/lbs…

view full answer...