Replacement Mounting Bracket for Valley Odyssey 52810 Brake Controller

Question

Question:

Hello, Could not find an phone number. I have a Valley Odyssey 52810 brake controller. The bracket broke and Valley does not appear to make brake controllers any longer. The controller is 3.263 W so 3.25 inside for the bracket and 1 from inside of bracket to screw hole clearance needed. I can drill this. Do you have anything I can use?

asked by: Scott H

1

Helpful Expert Reply:

The closest option we have to what you are looking for is part # P7685, which measures 3-3/16 inches inside width.

expert reply by: John H

1

Answer 1

The Tuson Electronic Sway Control System for Electric Trailer Brakes #335TSC-1000 has installation instructions that give a placement location on the center of your trailer and 5-10 feet behind the hitch ball. The unit comes with a wiring harness so…

view full answer...

Answer 2

I didn't see what vehicle you were using but if it is a Chevrolet Equinox then the stop light switch wire cannot be obtained at the brake pedal because it does not carry enough voltage. The stop light switch wire must be accessed inside an…

view full answer...

Answer 3

Your 2000 Chevy S-10 is not prewired for a brake controller, but that's not a huge deal. The hardwire installation is actually pretty simple. To begin with, you'll need a functional 4 pin trailer connector. If you don't have one already,…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 7

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 8

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Replacement Mounting Bracket for Valley Odyssey 52810 Brake Controller

Product Page this Question was Asked From

Continue Researching