Can Factory Hitch of 2017 Ram 1500 Express be Replaced with Aftermarket Hitch

Question

Question:

I have a 2017 ram 1500 express with all the electric and a full bumper from factory. I want to take off the whole assembly and replace with class 3 or 4 can you give me some options please. I wont need any wiring as it has it

asked by: Keven T

0

Expert Reply:

If you sourced a new bumper beam for your 2017 Ram 1500 that didn't have a factory hitch built into it you could then install an aftermarket Class IV hitch like the Draw Tite part # 41948. If that was what you were planning on doing you'd be set.

expert reply by: Jameson C

0

Answer 1

To install a Class IV trailer hitch, like the Draw-Tite Ultra Frame Trailer Hitch Receiver #41948, on your 2016 Ram 1500 you will need to have the OEM trailer hitch removed. We do have options like this for 2500 and 3500 pickups but that is for heavy…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...