Determine if 2001 Roadmaster Monaco has Dana Front Axle for Stabilizer

Question

Question:

I am looking here to purchase an RM-RBK6-RSSA steering stabilizer from you. It says it will fit my 2001 Monaco Diplomat 38 DP. My question is this-What does without Dana Spicer front axle mean? Thank you very in advance,

asked by: Michael P

0

Expert Reply:

The Dana/Spicer front axle is an automotive axle manufactured component your Roadmaster Monaco could have been equipped with which the # RM-RBK6-RSSA is not compatible with. Look on the BOM Bill of Material number plate for a number that starts with 60 or 61.

expert reply by: Jameson C

0

Answer 1

Yes we've checked with Roadmaster in the past and the Reflex stabilizer part #RM-RBK6-RSSA is the correct fit for your 2000 Monaco Diplomat RV.

view full answer...

Answer 2

The mounting brackets can vary depending on the chassis of the vehicle they're going on. For your 2004 Roadmaster Monaco the confirmed fit is the Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class A Motor Homes #RM-RBK6-RSSA.…

view full answer...

Answer 3

If your 2000 Roadmaster Chassis is the Air Ride or Monaco then you need the Roadmaster Reflex Steering Stabilizer with Mounting Brackets #RM-RBK6-RSSA. If you have the Straight Axle Leaf Spring instead then you need the Reflex Steering Stabilizer…

view full answer...

Answer 4

To have an observation camera like #VCMS50LWT (left) and #VCMS50RWT (right) come on when turn signals are engaged the camera power wires need to be wired to those turn signal circuits. The cameras themselves plug in at the monitor with their 4-pin…

view full answer...

Answer 5

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 6

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...

Answer 7

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

view full answer...

Answer 8

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 9

Hey Scott, so we do have the SumoSpring Solo kit part #SSR-130-54 that is a confirmed fit for your 2018 Ford motorhome built on an E-450 chassis.

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

I found the online version of the install instructions for the Exact Center stabilizers like the #RM47MR. What's fun is that just when you think you have found the correct step to address your problem it tells you to continue to the next step.…

view full answer...

Answer 12

For your 2024 Ford F-53, I recommend checking out the Timbren Front Suspension Enhancement System #TFFF53B for the front, and the Timbren Rear Suspension Enhancement System #TFRF53A for the rear. These kits do not require drilling, will replace your…

view full answer...