Replacement Wet Bolt for Suspension of 2012 Salem 30KQBSS

Question

Question:

Hello. Im trying to figure out which wet bolt with bushings kit is compatible with my travel trailer. It is a 2012 Salem 30KQBSS with Lippert axles. Can you please point me in the right direction? Thank you

asked by: Derek D

0

Expert Reply:

The standard wet bolt for trailer suspension would be the part # 126B2 which is 3-5/16 inches long and 9/16 inch in diameter.

expert reply by: Jameson C

0

Answer 1

The "LCI35" indicates that your Lippert axle uses 3,500 lb bearings and seals, and the correct bearing kit is the following: - Hub Bearing Kit for Lippert, Dexter, and Al-Ko Axles #BK2-100 Then for wet bolts you can use the Wet Equalizer…

view full answer...

Answer 2

It really shouldn't matter what direction the wet bolts part #126B2 install when used for equalizers or shackle straps. But if Dexter says to install them in the orientation you described then I would recommend you stick with their…

view full answer...

Answer 3

I spoke to my contact at Lippert Components Incorporated (LCI) about the Equa-Flex Cushioned Equalizers that you have on your trailer. They informed me that the equalizer does not need to be greased regularly though it would not hurt to spray a bit…

view full answer...

Answer 4

While we don't have a kit with the parts you need that have those measurements, we can easily piece it together. You will just need the following: - Straight Equalizer for 1-3/4" Double-Eye Springs - 5-1/2" Long - 9/16" Center Hole…

view full answer...

Answer 5

On the wet equalizer bolt #126B2 it does not matter which way the hole faces. Up, down, left, right, anywhere in between, it's all good. A lock nut has mismatched threads a little ways along the thread spiral and either its threads, the bolts…

view full answer...

Answer 6

I would be happy to help you find the correct replacement leaf spring mounting bolts for your 2020 Forest River Wildwood Heritage Glen 22RBHL Travel Trailer but unfortunately we do not have a break down of the components used on a specific trailer.…

view full answer...

Answer 7

Thank you for the photo. Based on that you can use either Shackle Bolt with Locknut #166081 or Wet Equalizer Bolt with Locknut and Grease Zerk #126B2. These are the exact same 3-5/16" bolt with 9/16" diameter and the only difference is that…

view full answer...

Answer 8

I have attached a link to our selection of suspension bolts that you can filter through. You will just need to make sure that the bolt you use as a replacement has the correct specs. Among the linked bolts is the Redline Wet Equalizer Bolt for Double…

view full answer...

Answer 9

Thank you for providing a photo of your trailer shackle straps showing the extra non-threaded portion of the Redline zerk-fitted bolts #126B2. Shackle bolts are intended to have a fairly loose fit with the shackle straps when installed properly. This…

view full answer...

Answer 10

Since your batteries are wired so that the two 6 volt batteries are in series and produce an output of 12 volts the part #329-GENIUS5 would be a great option. If you want to charge the batteries individually or if you want the total output to remain…

view full answer...

Answer 11

There are two ways to wire up two batteries. One way doubles the volts of the two batteries and the other keeps the same amount of volts. In parallel the voltage stays the same and in series it is doubled. Check out the diagram for more info.

view full answer...

Answer 12

In order to charge your batteries wired in parallel with the NoCo Genius #329-GENIUS5 you'll want to connect the positive charge line to the positive terminal of the first battery and the negative line to the negative terminal of the opposite…

view full answer...

Replacement Wet Bolt for Suspension of 2012 Salem 30KQBSS

Product Page this Question was Asked From

Continue Researching