Can I Use the B&W Gooseneck Ball BWGNXA2062 with a Curt OEM Style Gooseneck Hitch for 2019 Ram 3500

Question

Question:

Will the BandW Gooseneck ball Item # BWGNXA2060 fit the Curt OEM Style Gooseneck hitch #60633 that I currently have installed on my 2019 Ram 3500? I like the idea of the handle on the BandW for removal instead of the tab on the curt to avoid getting grease on my hands. The storage case would be nice too, but unfortunately the safety chain loops would not be needed.

asked by: Colin

1

Helpful Expert Reply:

Yes. You can use the B&W Ball and Safety Chain Loop Kit # BWGNXA2062 with your Curt OEM Style Gooseneck Hitch # C60633, since the Curt gooseneck hitch is designed to emulate the OEM gooseneck hitch.

expert reply by: Erik B

1

Answer 1

I went to the warehouse and took some measurements of the Curt Ball and Safety Chain Loops #C60618 for you. The outside to outside dimension of the loop is 4-1/4 inches. I have attached a photo of the loop with the dimensions shown you can check out.…

view full answer...

Answer 2

Odds are you are just fine using the hitch ball from your 2017 Nissan Titan for your 2019 Ram 3500 with the OEM gooseneck connection. Just to be sure, I went out to our warehouse and took some measurements on the hitch ball that comes with the Curt…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Can I Use the B&W Gooseneck Ball BWGNXA2062 with a Curt OEM Style Gooseneck Hitch for 2019 Ram 3500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching