Recommended TorkLift SuperHitch For 2019 Chevrolet Silverado 2500/3500 Duramax W/ 6-1/2' Bed

Question

Question:

Ive got a 2019 Chevy Duramax w 6 6 bed, I have a camper and also will be pulling my 4000 lb boat . Which Torklift super hitch would you recommend, also I may tow my larger fishing boat also that weighs in at 7500 lbs. Thanks

asked by: Dan K

0

Expert Reply:

For your 2019 Chevrolet Silverado 2500/3500 Duramax with the 6-1/2' Bed I recommend the TorkLift SuperHitch Original Trailer Hitch Receiver # TLC1212 which has a 1700lb maximum tongue weight rating, and 17000lb maximum trailer weight rating which get bumped up to 2000lb tongue weight and 20000lbs when using a weight distribution system.

The # TLC1212 is a bullet proof Class V hitch that has two 2" receivers allowing you to tow a trailer and carry a bike rack or cargo carrier.

If your camper is an in-bed camper and you need an extender to allow you to hook up your boat trailer I recommend the TorkLift SuperTruss Hitch Extension for SuperHitch Trailer Hitch Receivers - 28" Long # TLE1528 which has a 750lb maximum tongue weight rating, and 7500lb maximum trailer weight rating, or a 1200lb tongue weight rating and 12000lb trailer weight rating when used with weight distribution system.

I included videos for each of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

The Reese #RP45292 you'd looked at is exactly what you'd need. You'll need to cut the bar down to the 24 inch length, and you'd then install it in your 2-1/2 inch hitch to provide a 2 inch receiver for your cargo…

view full answer...

Answer 2

To use a TorkLift 48" hitch extender you will have to change out your receiver on your 2019 GMC Sierra 3500HD Denali. The TorkLift Cannon Hitch Extension #TLE1648 will only fit the 3" receiver that comes on the Ford Super Duty…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

Yes, the Air Lift LoadLifter 5000 Air Helper Springs #AL57341 will fit your 2024 Chevrolet Silverado 2500 double cab with the Duramax diesel engine and factory puck system. We installed the upgraded Springs #AL88341 on a similar 2022 which I have…

view full answer...

Recommended TorkLift SuperHitch For 2019 Chevrolet Silverado 2500/3500 Duramax W/ 6-1/2' Bed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching