T58 Valterra Waste Valve at the End of Stock Waste Valve Pipe

Question

Question:

My black and gray waste valves are separate and so far back under the trailer that I can barely reach them. Can I install the T58 on the outside of the sewer connection pipes and then leave the original valves open all the time?

asked by: Valerie M

1

Helpful Expert Reply:

You can install part # T58 at the end of the pipe with the stock valve open all the time. Installing this is going to make life a lot easier and you won't have to crawl under your camper. I do recommend part # A05-0303 as well. The cement is going to ensure a tight water seal all the time.

expert reply by: Clayton O

1

Answer 1

The waste valve you came from, part #T58 is not a valve that uses glue because it is designed to attach to the RV side and the waste tube with the bayonet adapters on each side of the valve. We do have waste valves that do require gluing. I have…

view full answer...

Answer 2

You need to use a sealant like our Valterra ABS Solvent Cement #A05-0303 to seal the connections when installing the #T38. Without doing that you most likely would get leaks. You current setup will be glued too so it would require you to break it…

view full answer...

Answer 3

If you want to install the Valterra Waste Valve #T58 in the side position it will absolutely acceptable, yes. In fact, the accompanying photo shows it installed in the same way as you are asking about. I've also added a link to a video review of…

view full answer...

Answer 4

Yes, Bristol is a manufacture not a specific type of fitting. As long as the opening diameter and fitting type is the same then you can use one with the other. The Valterra Waste Valve item #T58 you were looking at is a straight pull manual valve…

view full answer...

Answer 5

Yes, Bristol is just the manufacture of the product. As long as the opening diameter and fitting type is the same then you can absolutely use one in place of the other. Unfortunately, we do not carry Bristol products but I have attached our waste…

view full answer...

Answer 6

Your thinking is 100% correct here. RV black water drains will be a standard 3" size, which is the internal diameter of the pipes, so the Valterra Waste Valve for RV Black Water Tank - Twist On - 3" Bayonet Hooks to 3" Lug #T58 will…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Answer 9

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 10

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 11

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

T58 Valterra Waste Valve at the End of Stock Waste Valve Pipe

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching