Can NOCO 329-GCP1 Be Directly Wired to Oulet

Question

Question:

I just received my GCP1 and I have a question. Can I cut off the extension plug and wire to an outlet. I want to have a clean installation for an outlet vs having a loose pigtail hanging.

asked by: Scott

1

Helpful Expert Reply:

The female end of the # 329-GCP1 could be removed and directly connected to an outlet if you wish, although the product wasn't designed for use in that manner.

expert reply by: Mike L

1

Answer 1

You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…

view full answer...

Answer 2

If you installed a decently sized deep cycle battery on your trailer you wouldn't have a problem powering the LED lights of it for the length of time mentioned since LED lights draw a fraction of the amperage as incandescent. Group 24, 27, and 31…

view full answer...

Answer 3

To charge the 4 battery bank on your 2004 Discovery 39 I recommend using the NOCO GENPRO On-Board Battery Charger - AC to DC - Waterproof - 4 Bank - 12V - 40 Amp #NOC84FR, which will charge batteries rated for up to 230 amp hours. You can also add…

view full answer...

Answer 4

I attached a link to this page that has the install instructions for the Axle Riser Kit #LC382741 that you referenced.

view full answer...

Answer 5

According to Lippert, the mounting nuts should be torqued to 120 ft-lbs for the Axle Riser Kit - Single Square Torsion Axle - 3-1/2" Lift #LC382741.

view full answer...

Answer 6

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 9

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 10

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 11

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 12

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Can NOCO 329-GCP1 Be Directly Wired to Oulet

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching