Does 3 Inch Valterra Bladex Waste Valve Have Spaces on Side Without Seals In  

I've included a measurement diagram of the Valterra Sewer Valve #T1003VP. It is a standard RV waste valve.

If you're just looking to replace only the valves and nothing else then you'll just need the Valterra Bladex Waste Valve Body #T1003VP for your black tank and the Valterra Bladex Waste Valve Body #T1001VP for your gray tank. These valves just…

For the Valterra #TC372 the bolt pattern is 3-3/4", and the overall length, minus the protrusion, is 13-7/8". For the Valterra #TC172 the bolt pattern is 2-1/2", and the overall length, minus the protrusion, is 9-1/4". I have…

Looking more closely at the product pictures we have for the Valterra Bladex Waste Valve #T1003VP you can see the gaps in those pictures as well. It's a fairly common question with this design, but the rubber gaskets are designed to prevent…

This is a pretty common issue as the 12 volt accessory/charge circuit is not always active on vehicles with OEM 7-ways. The solution is to run 10 gauge wire like part #10-1-1 (sold by the foot) through a breaker like part #9510 between the 1:00 pin…

The Valterra Double RV Waste Valve, #T84B, has an overall measurement of 11-3/4" from edge to edge.

The Lippert Flow Max RV Toilet #LC67AF requires approximately 11-1/4" of space from the wall to the center of the drain.

The Ultra Breeze Trailer Roof Vent Cover which fits over your Dometic vent FV1400 is available in Black #DMC38FR or White #FVU1500WH. These covers are custom molded so the vent lid fits into the cover when opened.

While in theory, you would be able to use the Camco Automatic Changeover 2-Stage Propane Regulator #CAM59005 to switch from one propane tank to another while using your generator. The issue actually comes from the generator and more specifically the…

The Progressive Dynamics PD9100L part #PD9160ALV is exactly what you are looking for. It's a lithium only battery charger that is rated for 60 amps so it would be perfect for you.

I agree, that note doesn't make sense. When I reached out to my contact at MORryde they said the MORryde RV Generator Slide Out Tray #MR79RR doesn't have a stopper for when the tray is in the fully opened position so you just need to make…

You as the consumer wouldn't be able to adjust the puck system as it's typically welded to a frame that's attached to the vehicle's frame. Manufacturers do make mistakes so you could have a bad puck system from the factory and would…