Determining The Correct Replacement Waste Valves For A 2004 Airstream Safari LS Travel Trailer

Question

Question:

I believe I just need to replace the valves. Here is a picture of the setup.

asked by: Glenn A

0

Expert Reply:

If you're just looking to replace only the valves and nothing else then you'll just need the Valterra Bladex Waste Valve Body # T1003VP for your black tank and the Valterra Bladex Waste Valve Body # T1001VP for your gray tank.

These valves just get bolted to a flange or double waste valve setup with four bolts. If you can send in a picture of what all you'd like replaced I can help you find the parts you need.

expert reply by: Kevin C

0

Waste Valve Setup - Valve Replacement
(click to enlarge)

Glenn

7/22/2022

I believe I just need to replace the valves. Here is a picture of the setup.

Reply

Kevin C.

7/22/2022

If that's all you need then just unbolt your old ones from the hub flange and swap in the new ones and re-bolt them on with the same hardware and you'll be good to go. Definitely wear gloves though since you're working on waste valves and they typically don't ever get fully cleaned.

Reply

Answer 1

We have a couple of options to replace the lift tool that helps you get the spring bars in place on the Blue Ox weight distribution systems. I have listed them below: Replacement Spring Bar Lift Tools for Blue Ox TrackPro and 2-Point Weight…

view full answer...

Answer 2

There isn't a guide showing the exact black tank waste valve used on your 2016 Airstream so I have a few examples for valves you can use. If you are replacing just the valve between two flanges then the Valterra Bladex Waste Valve Body for RV…

view full answer...

Answer 3

Looking more closely at the product pictures we have for the Valterra Bladex Waste Valve #T1003VP you can see the gaps in those pictures as well. It's a fairly common question with this design, but the rubber gaskets are designed to prevent…

view full answer...

Answer 4

Thank you for your purchase from etrailer of the Valterra Bladex Waste Valve Body for RV Black Water Tank - Plastic Handle - 3" Diameter #T1003VP. As you can see from the accompanying photo, it is normal for their to be a little space on each…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

The Kuat Sherpa 2.0 #SH22G and the NV 2.0 #NV22G that you referenced are both excellent platform-style racks that will hold your bikes by the front wheels with no frame contact. These are top-of-the-line carriers and you really would not go wrong…

view full answer...

Determining The Correct Replacement Waste Valves For A 2004 Airstream Safari LS Travel Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching