SnapPad Jack Stand Pad System for Winnebago Workhorse Sightseer

Question

Question:

Mfr. said a Snap Pad Prime 4 pack was needed which is P/N PRSP4. I have a Class A Winnebago Workhorse Sightseer WPD26P with a Kwikee Level Best Leveling System On your site I see P/N SP64 FR4 listed for 10 Rounds Pads. Nothing says Snap Pad Prime series. Are they the same models?

asked by: Jim

1

Helpful Expert Reply:

I found the Snap Pads you need for your Winnebago Workhorse Sightseer WPD26P with the part # SP84FR. These are sold individually so you'd need to order a quantity of 4 of these.

expert reply by: Jameson C

1

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 3

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…

view full answer...

Answer 4

Demco actually has a kit that was designed to convert an Air Force One kit to a Stay in Play DUO which is what you would need since you have hydraulic brakes with the part #SM99231. This will work with what you have now and work great. If you send me…

view full answer...

Answer 5

The laws can be a little fuzzy and vary from state to state but it seems like if the trailer couples to a ball then you have to have safety chains. Technically, by using Bulldog adapter #BD0289640300 the gooseneck trailer is no longer coupling to a…

view full answer...

Answer 6

The Valterra Dual RV Water Inlets #A01-2001VP is going to be the closest thing we have to fitting your cutout area, so your best bet is to make your cutout a little larger to accommodate this fitment. Aside from that, everything else available is a…

view full answer...

Answer 7

The male thread of the Replacement Adapter Fitting #T4871700 being longer would not be an issue when installing it in the back of the Dexter actuator part #K71-650. Pressure from the male side flare fitting to the actuator is what seals it so the…

view full answer...

Answer 8

There is no specific torque rating for shackle bolts. Basically for the middle bolt there should be enough free play in the shackles to allow them to move. Tightening the shackle bolts too much will squeeze the shackle straps against the leaf springs…

view full answer...

Answer 9

It looks like the pictures didn't come through, however, your trailer is common enough where we have answered something like this before. With that being said, we do have a couple options for you: The most common type of lift kit is the…

view full answer...

Answer 10

I can absolutely confirm the correct lift kit for your trailer. Based on your photos, you do in fact have a #10 Torflex axle, and they are compatible with the lift kits because you do not have 3" high-profile brackets (which just means the…

view full answer...

SnapPad Jack Stand Pad System for Winnebago Workhorse Sightseer

Product Page this Question was Asked From

Continue Researching