Valterra Dual RV Water Inlet Recommendation for 5-1/2" Wide x 3-1/4" High Cutout
Question:
My water Inlet measures outside 7.1/2 wide x 5.1/4 high vertical and the CUT OUT area is 5.1/2 wide X 3.1/4 high vertical. This a01-2001vp model is close bur not exactly. CUT OUT area is 5.3/4 wide by 3.7/16 high. Do you have one with my demensions or any suggestions. My Rv is a Keystone Cougar, 2011
asked by: Alysia
Expert Reply:
The Valterra Dual RV Water Inlets # A01-2001VP is going to be the closest thing we have to fitting your cutout area, so your best bet is to make your cutout a little larger to accommodate this fitment.
Aside from that, everything else available is a standalone inlet with a circular cutout installation that isn't even close to what you're needing.
Product Page this Question was Asked From
Valterra Dual RV Water Inlets - City Water and Gravity Fill - Plastic Valve
- RV Water Inlets
- City Fill Inlet
- Gravity Fill Inlet
- Surface Mount
- 1/2 Inch Deep
- Plastic
- 7-1/2 Inch Diameter Flange
- Plastic
- White
- Valterra
more information >
Continue Researching
- Q&A: Wiring Needed To Operate Winch On Trailer From Truck Battery
- Q&A: Everchill Model WD-282FWDC-B-6 RC refrigerator
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Can You Flat Tow a Ford Escape?
- Q&A: Cutout Dimensions for the Valterra City Water Inlet # A01-2001VP
- Q&A: Replacement Leaf Springs for 2011 Eclipse Stellar Toy Hauler
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Q&A: Do Trailer Slipper Springs Normally Slip Out of their Rear Hangers
- Q&A: Troubleshooting Triple Axle Trailer with Rear Axle Off The Ground
- Q&A: Recommended Hanger Spacing for Triple Axle Trailer
- Article: How to Raise Your Travel Trailer Height