WeatherTech Side Window Rain Deflectors for 2019 Thor Synergy 24SK Motorhome

Question

Question:

I have a 2019 Thor Synergy 24SK motorhome. will these fit it or do you have something else that would fit. I also would like to get a bug shield/wind deflector, do you have one that will fit?

asked by: Jeffrey M

0

Expert Reply:

For your 2019 Thor Synergy 24SK motorhome, the Sprinter frame and front end on your motorhome will allow you to use rain guards. You will want the WeatherTech # WT64AV for the rain guards, but we do not have a bug shield compatible with your motorhome.

expert reply by: Jason S

0

Answer 1

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 7

When putting the Roadmaster Falcon 2 All-Terrain Non Binding Tow Bar, item #RM-522, in the storage position while it is mounted in the tow vehicle receiver hitch you will need to put one arm in each hand, like pushing a wheel barrow. Then level the…

view full answer...

Answer 8

I'm guessing whoever it was asked for your VIN to try to determine if you have the standard E-350 or the Super Duty which is the extended model. It looks like the standard, or Econoline/Club Wagon, uses the square plug you have seen like what is…

view full answer...

Answer 9

In order to confirm the correct replacement motor for your steps I would need either the model number of the step or the part number on the motor. I have attached a photo for you that shows how to find the step model number. That said, if the number…

view full answer...

Answer 10

I've attached the installation instructions for the Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch - Remote - 2,000 Watts - 12V #PD64FR for you below.

view full answer...

Answer 11

This has come up in the past and Progressive Dynamics has confirmed that yes you can wire the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4135K you're looking at to an automatic transfer switch.…

view full answer...

Answer 12

The Prodigy P3 trailer brake controller uses a 4-wire hookup. The white wire is to be grounded to the battery negative terminal; the black power wire connects to the battery hot terminal through a circuit breaker; the red wire takes in the brake…

view full answer...