Can the Trailer Valet JXC Trailer Jack Be Painted

Question

Question:

I am considering putting this on a custom boat trailer and I was wondering if I would be able to paint the surface on this trailer jack?

asked by: Daniel H

0

Expert Reply:

The Trailer Valet JXC Trailer Jack part # TV54FR has a nice wrinkle black powder coated finish. If needed, the powder coat could be sanded down and repainted/coated in a color of your choosing no problem.

expert reply by: Conner L

0

Answer 1

For this range of length in a Class C RV cover, we have the Adco Olefin HD All-Climate Cover for Class C Motorhome, #AD34ZR. This is a great option for long-term storage in all climates and fits Class C RV's that are 26'1" -…

view full answer...

Answer 2

?The distance from the mounting plate to the foot on the Trailer Valet JX-2K #TV54FR is 13" when fully retracted. The distance from the mounting plate to the top of the jack is 23". This jack can provide you with up to 14"…

view full answer...

Answer 3

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 4

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer…

view full answer...

Answer 5

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…

view full answer...

Answer 8

Hi Tom, I have two options to replace the electric tongue jack on your Jayco Whitehawk: Option 1: Electric Jack w/ Footplate #EJ-3520-BBX. This jack is going to be your no-frills 'get the job done' style jack. It has a 3,500lb capacity and…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...