Are AutowBrake Electric Brake Controller Key FOBs the Same

Question

Question:

Are the remotes the same, if we purchase 20 of them, will one remote work on multiple units is my questions?

asked by: Barry

0

Expert Reply:

All of the FOBs/remotes of the AutowBrake part # 3430001 operate on the same frequency so if you ordered 20 of these you wouldn't have to worry about keeping them straight.

expert reply by: Jameson C

0

Answer 1

The lever on the side of the Hayes #HA81742B Energize III brake controller is what levels the internal pendulum for the accelerometer that determines how quickly the vehicle is braking. Once installed, the lever should be pointed downward, at a…

view full answer...

Answer 2

The tire on the Kenda 165/65-8 Bias Trailer Tire with 8" White Wheel - 4 on 4 - Load Range C #AM3H200 has a speed rating of 65 mph. This wheel and tire combo has a maximum capacity of 800 lbs (per wheel/tire) and fits a 4 on 4" bolt…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 10

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 11

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 12

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Are AutowBrake Electric Brake Controller Key FOBs the Same

Product Page this Question was Asked From

Continue Researching