Best Trailer Tire in Size ST225/75R15

Question

Question:

Harbor View 7,250 lbs before we added our stuff trailer. I purchased a spare from you. OEM are E rated and I had kept them at 70 psi. Trailer is 2 years old. Within past month I’ve had two blowouts on the OEM tires and I want to avoid this as my top priority in purchasing tires. I obviously want radial E rated. To minimize my problems, I want to have the best. I see four choices available. Can you recommend my smartest choice.

asked by: Gene D

0

Expert Reply:

The best trailer tire we have in the size ST225/75-15 is the Karrier part # AM10303. This has a speed rating of 81 mph and a weight capacity of 2,830 lbs at 80 psi plus a limited 5 year warranty and a 1-year worry-free guarantee.

expert reply by: Jameson C

0

Answer 1

Tire failure is usually caused by a few things. It can be from overloading the trailer, improper tire inflation, and/or exceeding the speed rating for the tire. You should verify that the tire capacity you have for you trailer is adequate for how…

view full answer...

Answer 2

Replacing the passenger tires you have on your trailer as soon as you can is a smart idea as passenger vehicle tires are not rated properly for trailer use and they would be very likely to fail. In the tire size of ST225/75R15 the best option is the…

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 6

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 7

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 9

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 12

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

view full answer...