How Does Replacement Clamp for Extang Trifecta EX1034 Install

Question

Question:

how do i change a cab twist latch on a extang trifecta 2.0?

asked by: Melissa V

0

Expert Reply:

I spoke with my contact at Extang a while back about the install of the front clamp for Trifecta Cover part # EX1034 and he said that you need to disconnect the screws from the crossbow of the cover so that it will drop down and the cab clamp assembly will then be able to slide out of the rail. I attached a picture that illustrates this as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I reached out to Extang directly regarding your inquiry on the Replacement Cab Clamp #EX1034. They advise to release the clamps, remove the tarp from the rails so that the frame loses enough tension to be pulled apart. Included is the tarp…

view full answer...

Answer 2

I spoke with my contact at Extang about the install of the front clamp for Trifecta Cover part #EX1034 and he said that you need to disconnect the screws from the crossbow of the cover so that it will drop down and the cab clamp assembly will then be…

view full answer...

Answer 3

None of the methods are super easy. I'd recommend three though you have to remove hinges. This is least invasive, doesn't require cutting the cover, and also doesn't risk damaging cover.

view full answer...

Answer 4

You certainly can substitute the #EX1035 tail clamps with the #EX1034 cab side clamps for a more snug connection. Extang tells me that doing so is perfectly acceptable, but it will make removing the cover more difficult.

view full answer...

Answer 5

In order to install the Replacement Tail Clamp Assembly for Extang Solid Fold and Trifecta Tonneau Covers part #EX1035 you'll simply remove the hinge cap, slide the old clamp off, slide the new clamp on, then reinstalled the hinge cap. I have…

view full answer...

Answer 6

Yes, the Replacement Cab Clamp Assembly part #EX1034 is a fit for a Extang Trifecta 2.0 Soft Tonneau Cover. In regards to installation, you'll need to disconnect the screws from the crossbow of the cover so that it will drop down and the cab…

view full answer...

Answer 7

When installing the Replacement Cab Clamp Assembly #EX1034 on your Extang Tonneau Cover you will first need to remove the screws from the crossbow/support rail of the cover. This is what will allow you to both remove the existing/damaged cab clamp as…

view full answer...

Answer 8

I spoke with my contact at Extang regarding the removal of the existing cab clamp on your Trifecta Tonneau Cover. She stated that on the Trifecta covers, after you have removed the screws that hold the cross member in place, you will then need to…

view full answer...

Answer 9

I was able to use the cover part number you provided, 060308-44630, to confirm with my contact at Extang which replacement parts you need. For the Cab Clamp use part #EX1034; for the Tailgate Hinge use #EX1033; and for the tarp portion use part…

view full answer...

Answer 10

I spoke with my contact at Extang about the install of the front clamp for Trifecta Cover Clamp part #EX1034 that you referenced and he said that you need to disconnect the screws from the crossbow of the cover so that it will drop down and the cab…

view full answer...

Answer 11

It sounds like you're looking for the Replacement Cab Clamp Assembly for Extang Trifecta Tonneau Covers part #EX1034 which is a direct replacement for Extang Trifecta Tonneau Covers. The clamp assembly simply slides into the existing track under…

view full answer...