How Does Furrion Chill Replacement RV Air Conditioner Get Power

Question

Question:

CAN A POWER INVERTER RUN THIS AC UNIT

asked by: Kevin S

0

Expert Reply:

The Furrion Chill Replacement RV Air Conditioner for Advent Air Setup - 13,500 Btu - White # FR82PV is run off of 115V, 60Hz or what most of us consider 110/120V or AC power.

A power inverter takes the DC electricity from the RV's battery (12V) and converts it to AC power (120V). That way all of your household appliances can run in your RV.

So the RV will need to be hooked to shore power, or have the generator and inverter running in order to power the AC. The AC unit does use 14.6 amps while running so you want to make sure that the circuit can handle that load as well.

expert reply by: Robert C

0

Answer 1

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 2

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 3

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 4

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 5

Hey Jon, Yes, the Advent Air Low Profile RV Air Conditioner #ADV79FR is compatible with the Air Distribution Box #ACDB. This would have the controls on the air distribution box instead of a wall mounted thermostat. We don't currently have any…

view full answer...

Answer 6

Hi Robert, If you're just wanting to replace the condenser unit on the rooftop and retain use of your current air distribution box and thermostat then you'll just need to determine what style connector your current unit has. If you remove the…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 9

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 10

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 11

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 12

If you have the ACTH12 then you should also have the Air Distribution Box #ACRG15 which will have a control box for your wiring from the rooftop unit #ACM135 and the thermostat. This air distribution box and thermostat will wire up exactly the same…

view full answer...

How Does Furrion Chill Replacement RV Air Conditioner Get Power

Product Page this Question was Asked From

Continue Researching