Are Bulbs Replaceable on LED Light Kit for Post-Style Boat Guide-Ons

Question

Question:

Are the LED bulbs in this light replaceable when they burn out?

asked by: Ed M

0

Expert Reply:

The LED lights are sealed so they are not replaceable on the LED Light Kit for Post-Style Boat Guide-Ons # CE27656A.

That said, LEDs are made to last for years or over a decade depending on your usage. And for a boat trailer that is only going to see moderate usage compared to LEDs in a home or on a vehicle, there is a far better chance of essentially any other part on a trailer needing to be replaced than these lights.

expert reply by: Kyle S

0

Answer 1

The LED Light Kit for Post-Style Boat Guide-Ons, #CE27656A, will wire into the running light circuit of your boat trailer for power. They do have ground wires and will need to be grounded to a clean, corrosion free bare metal surface. Or if…

view full answer...

Answer 2

The LED lights on the CE Smith Post-Style Guide-Ons #CE27760 do not have separate wiring for only the red portion of the LED Cap Light #CE27656A. They are normally used to act as running lights to make maneuvering the trailer easier in low light…

view full answer...

Answer 3

The option we have for an LED light kit for post-style guide-ons for a boat trailer the LED Light Kit for Post-Style Boat Guide-Ons #CE27656A. These will fit on 2-3/8" outer diameter post-style PVC boat guides, but there isn't a way to wire…

view full answer...

Answer 4

There are a few things that could cause one side of your brakes to drag after adjusting. This could be either a broken spring, faulty adjuster screw, or possibly a pinched wire on that side but you would hear the magnets buzzing if this was the case.…

view full answer...

Answer 5

Since trailer leaf springs tend to stretch over time the key to picking out the correct replacement is to go with one slightly shorter than what your current one measures. So a 26 inch long spring would most likely be what you need. For a 2,000 lb…

view full answer...

Answer 6

It looks like the lock is on a bed topper/camper shell or a custom utility bed. Without being able to see the entire lock cylinder removed from the assembly to see how it connects to the actuating arm for the lock, I couldn't say if any of the…

view full answer...

Answer 7

The psi should be listed on the sidewall of the tire. It is recommended that tires always be inflated to the max psi. The max psi of the tire will depend on the tire's load range, not the weight of the trailer. For instance, we carry 5.30-12…

view full answer...

Answer 8

I spoke with CE Smith and they told me that the distance between the two smaller holes is 2". Attached is a diagram of this measurement for your reference.

view full answer...