Capacity of Timbren ASR1THDS02 Axle-Less Trailer Suspension System

Question

Question:

Are these rated 1100lbs each for a total of 2200lbs? Thx

asked by: Kevin C

0

Expert Reply:

That's absolutely correct. The combined capacity of the two units included with part # ASR1THDS02 is 2200 lbs. I've linked you to a product demonstration video.

expert reply by: Mike L

0

Answer 1

Timbren Axle-Less Trailer Suspension for Off-Road Tires #ASR1THDS03 has maximum deflection of 3-3/8-inches when used within its rated weight capacity. This is noted in the linked diagram. For off-road use the improved ground clearance from completely…

view full answer...

Answer 2

I reached out to a representative of Timbren who told me that the 3-3/8 inch deflection of the Timbren Axle-Less Trailer Suspension System #ASR1THDS02 is with a loaded trailer. As for the 5-5/16 inch measurement also shown in the photo, that is the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 8

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 9

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 10

I attached a picture that shows how much of the etrailer.com hitch part #E98901 would hang below the rear bumper when installed.

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...