Availability of Shorter Version of the Optronics Conspicuity Tape # RTR15066PB

Question

Question:

Do you sell the Optronics reflective tape RTR15066PB in shorter lengths as I was short 20 ft on the role I brought from you a few weeks ago.

asked by: Daniel A

0

Expert Reply:

We have the 18 inch version of the Optronics reflector tape part # RE18T similar to the # RTR15066PB you referenced.

expert reply by: Jameson C

0

Answer 1

The Custer Clear Conspicuity Reflector, 12" Long #RFL-12W does not have any screw hole covers. The only way to get away from the screws is to use the White Conspicuity Tape, 150' Roll #29804 which is 2 inches wide and can be cut to…

view full answer...

Answer 2

If you check out the help article I attached below you'll see info on when conspicuity tape is needed like part #RTR15066PB for 6 inch by 6 inch or part #RE18T for 7 inch by 11 inch. The size differences basically come down to what best fits…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 7

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 9

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Availability of Shorter Version of the Optronics Conspicuity Tape # RTR15066PB

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching