Roof Rack that Can Fit 2018 Lance Camper 865

Question

Question:

I’m looking for cross bars for my 2018 lance truck camper 865. Cannot find them. Thanks

asked by: Robert H

0

Expert Reply:

I recommend taking a look at the Swagman Roamer LT Roof Rack # S80510. This particular roof rack is designed for truck caps and campers and features a weight capacity of 150 pounds. The included feet will bolt on with the included hardware (drilling required) and the two square crossbars will work with most clamp-on accessories. The crossbars are 84-5/16 inches long but can simply be cut down to size.

I have attached the written installation instructions for this system so you can see exactly how everything will install on your camper.

expert reply by: Jameson C

0

Answer 1

I recommend using 4 sets of the Rhino-Rack Roof Rack for Factory Tracks #Y02-490B-NT for your application. This comes with 2 of the crossbars, legs, and pad setups so it's more cost-effective than piecing out everything, plus the crossbars and…

view full answer...

Answer 2

After you drill into your camper to install the Swagman Roamer LT Roof Rack for Pop-Up Campers and Camper Shells #S80510, there are three things that will go underneath (on the inside) of the camper: the metal plate, a washer, and a nut. As far as…

view full answer...

Answer 3

According to the installation instructions which I've linked, the included lag bolts will work as long as there is a piece of structure under the location where you've drilled the hole. Otherwise, they recommend using the provided 6mm x 80mm…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 6

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 7

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

view full answer...

Answer 8

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 12

You'd need a new panel like the Progressive Dynamics Mighty Mini part #PD4045KA which is the most similar to your Parallax 7345 except is Lithium battery compatible. There isn't a center section replacement available for what you have that…

view full answer...