Wheel Caster to be Used with Ultimate Trailer Jack

Question

Question:

What wheel do you recommend for the ultimate trailer jack? Thanks

asked by: Mike K

0

Expert Reply:

The wheel caster you need is the part # JC-102 to be used with the Ultimate Trailer Jack # 322-RDJ-2K.

expert reply by: Jameson C

0

Answer 1

The Ultimate Trailer Jack part #322-RDJ-2K is the lowest profile trailer jack and would work great for you. Since the bracket is adjustable you can set the height of the jack at a very low height as needed.

view full answer...

Answer 2

I went out to the warehouse and found that the distance from the center of the jack to the furthest part of the adjustment pin on the Ultimate Trailer Jack #322-RDJ-2K when it is pulled out is 5-3/8". If you have this much room from the center…

view full answer...

Answer 3

The Bulldog #BD155033 has bottom of mounting bracket to bottom of inner tube dimension of 5-13/16 inches when the jack is fully retracted. Its 2000 lb lift capacity is more than enough to handle the tongue weight of your trailer.

view full answer...

Answer 4

Yes, the Ultimate Trailer Jack part #322-RDJ-2K is the perfect option to prevent bottoming out the tongue jack since you can adjust the shaft on the base to ensure you have as much ground clearance as possible. It also makes lifting and lower the…

view full answer...

Answer 5

The #322-RDJ-2K Ultimate Trailer Jack can be rotated in any direction as long as one of the holes is facing forward. So rotating the jack will not be a problem. As for aligning the holes, I would not recommend modifying the jack in any way, since…

view full answer...

Answer 6

Yes, you can mount the Ultimate Trailer Jack part #322-RDJ-2K so that the release pin faces outward instead of towards the trailer. All you need to do is rotate the jack until the mounting holes line up and the pin is pointed away from the trailer.…

view full answer...

Answer 7

All A-Frame mounted jacks like the Ultimate Trailer Jack, part #322-RDJ-2K, use roughly the same 3-inch mounting hole bolt pattern. The mounting holes are also elongated to allow about 1/4 inch of extra mounting versatility. Simply put, A-Frame jacks…

view full answer...

Answer 8

The swiveling caster wheels for jacks attach to the inner jack tube so you'd want to match that. More importantly you'll want to match the brand of the jack with the caster wheel as there aren't any universal fits. I attached a link to a…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 10

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 11

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Wheel Caster to be Used with Ultimate Trailer Jack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching