What Wires To Splice Into For Pop & Lock Power Locking Handle for Truck Caps On 2019 GMC Sierra

Question

Question:

I am trying to hook the wires up but the wiring chart that came in the kit has 07+ and the wires specified are not working with the part. Can you please provide me with a newer chart or what to do?

asked by: Nicholas L

1

Helpful Expert Reply:

The correct lock and unlock wires to splice into on a 2016-2019 GMC Sierra to install the Pop & Lock Power Locking Handle for Truck Caps and Hard Tonneau Covers part # PAL9555 should be a tan with a yellow stripe and grey. That said, it is always best to test with a circuit tester before splicing.

expert reply by: Conner L

1

Answer 1

The Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 will work on the A.R.E. MX series truck cap you referenced on your 2017 Ford F-250 Crew Cab Short Bed. This will give you a clean look along with the keyless…

view full answer...

Answer 2

You can use 7-way trailer wiring with the module part #PP20-702 to provide power to the third brake light of your camper shell/cap. Basically the stop/turn circuits of the trailer wiring need to run to the yellow wires of this module and then the…

view full answer...

Answer 3

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers part #PAL9772 or part #PAL9555 will work on the Leer 100XQ Truck Caps because it uses a cable latching mechanism and the handle is not riveted on.

view full answer...

Answer 4

I reached out to my contact at Pop & Lock and sent him along the picture you attached of the latch on your Leer camper shell. He said based on the image the Pop & Lock Power Locking Handle #PAL9555 should work perfectly. The only reason I use…

view full answer...

Answer 5

The 2nd generation of the GMC Sierra ran from 2007 through 2013, so it's likely the wire location and color are the same. You'll want to test the wire just to be sure though. That being said, I would actually recommend tapping into the…

view full answer...

Answer 6

As long as your A.R.E. CX series truck cap has a single handle and not the two "T" handles then the Pop & Lock Power Lock Conversion Kit #PAL9772 will work. If you do have the "T" handles you will want to go with the Kit…

view full answer...

Answer 7

Based on my research, it looks like both the previous generation and later model years of the GMC Sierra featured easy to reach wiring for the dedicated brake light circuit on the truck. For your 2014 model Sierra though, these wiring harnesses are…

view full answer...

Answer 8

There may be a wire loom under the truck, above the spare tire with some tow package wires in it. If you cut back the loom, often times there will be 2 additional wires. The Light Blue wire provides a lead for a camper shell brake light. The other, a…

view full answer...

Answer 9

According to the Pop & Lock vehicle wiring chart, the lock wire is tan and the unlock wire is blue or gray on your 2017 Silverado 1500. However, you will need to verify this using a circuit tester like the #PTW2993. The lock wire will have power…

view full answer...

Answer 10

For a topper lock that ties into the power lock system of a truck we have the part #PAL9555 which would work well on your hard tonneau cover that you have installed on your 2017 Chevy Silverado 1500.

view full answer...

Answer 11

I recommend using the Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle #F2407, which are the only confirmed air bag currently available for a 2021 Toyota Tacoma. To add a compressor system I recommend using the Firestone Dual…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

What Wires To Splice Into For Pop & Lock Power Locking Handle for Truck Caps On 2019 GMC Sierra

Product Page this Question was Asked From

Continue Researching