What To Do If Bumper and Hitch Contact Each Other After Installation On 2008 Audi A4
Question:
I completed step 2 of placing the hitch to be level and square. It seems the horizontal bar hits my lower bumper. I was able to install it but it is touching. will this cause issue or damage or should I trim it?
asked by: Scott
Helpful Expert Reply:
The Curt Trailer Hitch Receiver part # 11164 which is a fit for a 2008 Audi A4 does not require trimming. However, the fit around the lower part of the bumper fascia where it meets the frame brackets for the hitch can be tight and in some cases touching. If the parts are touching it would be a good idea to go ahead and make some small cuts to alleviate some pressure as this then puts more stress on the fasteners. That said, you most likely would not run into any issues if just left the way it is.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Video: Trailer Hitch Installation - 2003 Audi A4 - Curt
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Search Results: thule big mouth
- Search Results: thule big mouth 599xtr
- Shop: Replacement Rear Wheel Holder Assembly for Thule T2 Pro Platform Bike Racks - Qty 1
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Search Results: lt37467
- Q&A: Trailer Hitch for a 2008 Audi A4 Quattro Sedan
- Shop: Trailer Wiring
- Shop: Curt Class II Drawbar - 3-1/8" Rise - 9-1/2" Long - 3,500 lbs
- Shop: Curt Class I Drawbar - 5/8" Rise, 1-1/4" Drop - 6-3/4" Long - 2,000 lbs
- Shop: Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1
- Shop: 1-7/8" Hitch Ball - 3/4" Diameter x 2-3/8" Long Shank - Chrome - 2,000 lbs
- Search Results: hitch mount
- Video: Curt Cam Buckle Stabilizing Strap Test Course
- Video: Curt Ball Mounts - Fixed Ball Mount - C45018 Review
- Q&A: Will Curt Hitch Work With 2004 Audi A4 Avant Wagon on Steep Driveway?
- Q&A: How Thick Is The Metal of Square Tubing On The Draw-Tite Trailer Hitch # 24677
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: 68149
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: dust cap
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Brake Controller
- Article: Trailer Wiring Diagrams
on Trailer Hitch
