Recommended Kayak Racks for 11-1/2 Foot Long and 85-lbs Kayaks on 2006 Nissan Xterra

Question

Question:

I own a 2006 nissan xterra and have two 85 lb. 11.5 ft fishing kayaks I am trying to find a rack to carry both with. The malone racks say 75lb max. What would you recommend?

asked by: Jessica

0

Expert Reply:

I have a solution for you, but I was able to determine from my research that the 2006 Nissan Xterra roof has a capacity of 150-lbs, so adding a kayak carrier and 2 kayaks that weigh 85-lbs each would put you over capacity of your roof. Your best solution for carrying kayaks of that length and weight would be using a kayak trailer like the Malone EcoLight # MAL43FR, which comes with extra wide kayak carriers that will fit a variety of different style boats.

If you don't already have a hitch, wiring harness and the other parts you'd need to tow a trailer, I've listed what I recommend using below.

Trailer Hitch: Curt # 13514
Wiring Harness: Curt # C56225
Ball Mount Kit: # 989900

I've also linked some installation and review videos of these parts for you to have a look at, as well.

expert reply by: Erik B

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Recommended Kayak Racks for 11-1/2 Foot Long and 85-lbs Kayaks on 2006 Nissan Xterra

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching