Happijac Camper Tie Downs that Fit 2005 Ford F-150

Question

Question:

I would like to make sure that these brackets fit my 2005 ford f150.

asked by: Justin C

0

Expert Reply:

Happijac has a set of camper tie downs that fit your 2005 Ford F-150 with the part # LC182860 but the part number you referenced does not fit your truck.

expert reply by: Jameson C

0

Answer 1

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

view full answer...

Answer 2

We do have the HappiJac Truck-Mounted Camper Tie-Downs, #LC182860 that are a confirmed fit for the 2004 Ford F-150. However, the TorkLift Custom Frame-Mounted Camper Tie-Downs - Front, #TLF2004, is a confirmed fit only for the 6-1/2' bed due to…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

Hey Cynthia, thanks for reaching out! We've got the Draw-Tite Class IV #75506 and the Draw-Tite Class V #41933 that fit your 2006 Ford F-150 STX as long as it doesn't have the factory hitch. I've attached some installation videos of these…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Happijac Camper Tie Downs that Fit 2005 Ford F-150

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching