Comparing Standard Door Lock to Ultra E Pro Electronic Lock for Security

Question

Question:

Hello How can your combination keypad be more secure than a key only lock since it still has key locks to bypass the keypad?

asked by: Robert

0

Expert Reply:

The keypad on the Global Link Ultra E Pro Electronic Lock for Travel Trailers # 295-000183 (right hand) or # 295-000185 (left hand) is more of a convenience factor than actually "more" secure when compared to standard handles like part # 295-000019.

Basically it keeps you from having to use a key when you are using the door daily. You are correct that since there are 2 lock cores like on a standard handle it would take the same amount of skill to get into a camper regardless of whether you have the Ultra E Pro or a standard handle.

expert reply by: Jon G

0

Answer 1

There are two different MORryde CRE3000 Shock Absorbing Suspension Equalizers for tandem axle trailers, part #MR87ZR for a 33" wheelbase or part #MR27ZR for a 35" wheelbase. There are also two different MORryde Suspension Upgrade Kits for…

view full answer...

Answer 2

Global Link RV Entry Door Locks are available with key codes G301-G390, however keyed alike options available through etrailer only include numbers G346-G350. If you're looking for the most effective way of securing your RV from potential…

view full answer...

Answer 3

We carry only a few entry door locking latch kit, like #295-000019, and all have the same basic measurements which is the standard size on most RV door. The door locking latches measure 3-15/32 inches wide x 4-9/32 inches tall. What that means is…

view full answer...

Answer 4

Only solution we'd be able to help with would be a new latch as we don't have the replacement key you are looking for. What you have looks very similar to the standard RV door latch like the Global Link RV Entry Door Locking Latch Kit…

view full answer...

Answer 5

You can definitely use the MORryde suspension bolts if that's what you're wanting to use. The correct kit depends on what your trailer is currently equipped with and how long your shackle straps are (see attached photo of where to measure).…

view full answer...

Answer 6

The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according to…

view full answer...

Answer 7

It does not matter if the label of the MORryde Shock Absorbing Suspension Equalizers for Tandem Axle Trailers #MR27ZR is facing in or out. You are totally find the way yours is installed.

view full answer...

Answer 8

According to my contact at MORryde, the UO12-021 which we refer to as part #MR76ZR would be compatible with the Lippert #LC279687 Equa-Flex cushioned equalizers if you're currently using 3-1/8 inch shackle links as long as you're not using…

view full answer...

Answer 9

The MORryde Shackle Upgrade Kit for Tandem Axle Trailers w/ 2-1/4" Shackles & Correct Track #MR58ZR you were looking at may work on your 2018 Highland Ridge Travel Trailer 322RL with Lippert 5200LB axles and the correct track alignment/lift…

view full answer...

Answer 10

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 11

I have attached a wiring diagram that will show the typical arrangement of the towing wiring on your vehicle and the corresponding wires on the trailer side. The basic wiring identification is as follows: Green - Tail & Running Light Black - 12V…

view full answer...

Answer 12

I suggest the Global Link RV Entry Door Locking Latch Kit, #295-000019. This will fit in to cutouts that are 2-1/2" to 3" wide and 3-1/2" to 4" tall on doors from 1-1/4" to 1-1/2" thick. You can also get this same latch…

view full answer...