Wiring Diagram for Switches of Bulldog Powered A-Frame Jack

Question

Question:

Can I please get a wiring diagram for the on off switch and all other wires under the cover, Thanks

asked by: Michael O

0

Expert Reply:

I attached pictures that show how the switches of the Bulldog Powered Jack # BD500187 get wired.

expert reply by: Jameson C

0

click to enlarge

Answer 1

When wiring up the Bulldog A-frame trailer jack #BD500187 you can use 12 gauge wire such as #12-1-1 (sold by the foot) as long as the distance from the jack to the battery is less than 20 feet. I am assuming that the battery is located at the front…

view full answer...

Answer 2

The breakaway battery of a trailer wouldn't have enough amperage to power the jack up and down and also it would drain it to point it wouldn't work as a breakaway kit. So you could power the jack from the 12 volt power circuit of the…

view full answer...

Answer 3

On the bottom of the motor of the Stromberg Jack part #SC63VR there is a release lever setup that gets inserted when you want to manually crank the jack to release it basically from the motor.

view full answer...

Answer 4

The etrailer and Pro Series A frame jacks will use 3/8 inch bolts, which is the standard size for A frame jacks and couplers. For install details and some product demonstration videos, click the provided links.

view full answer...

Answer 5

The Bulldog Powered-Drive Trailer Jack, item #BD500200, only has one wire, the power wire. This jack attaches to ground through the mounting hardware and the trailer frame. When wiring the jack to your 7-Way trailer connector you will need to make…

view full answer...

Answer 6

The wiring for the Bulldog Powered-Drive Kit #BD1824200100 is as follows for the four wires in the wiring harness. The Black wire from the battery goes to the Black wire on the harness The Red wire from the battery goes to the Red wire on the harness…

view full answer...

Answer 7

If your Husky Brute Electric Trailer Jack - Drop Leg - A-Frame - 24" Lift - 4,500 lbs, part #HT87247, has brakes that are no longer engaging and the jack no longer holds under load, it is time to replace your jack. The Stromberg Carlson Electric…

view full answer...

Answer 8

Our etrailer Electric Jacks Electric Jack w/ Footplate #EJ-3527-BBX are made by Pacific Rim. They also manufacture the Ram Jacks right alongside the etrailer.com jacks. Ram is a well known brand of dependable jacks in the industry and many trailer…

view full answer...

Answer 9

I attached a picture that I got from RAM jacks that shows how the RAM Jack switch part #EJ-3520-PSW that you referenced gets wired up.

view full answer...

Answer 10

We sure do! That is actually the circuit breaker of your Bulldog 3500lb Trailer Jack #BD500187. For a replacement you will need the Tekonsha 30 Amp Circuit Breaker #7012A which my contact at Bulldog confirmed. I included a video of the #BD500187 for…

view full answer...

Answer 11

None of those wire colors are standard ground wire colors. Typically it's a white wire. The rest of your wires look standard for the most part but since you don't have a white wire you may have to do some testing. You can try using a jumper…

view full answer...

Answer 12

I attached a wiring diagram for the Solera Power Awning Switch Kit #LC285500 for you to check out.

view full answer...

Wiring Diagram for Switches of Bulldog Powered A-Frame Jack

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching