Removal of the iRV RV Stereo part # 292-101809

Question

Question:

Hi, I need to remove my IRV35 to gain access to the back of the unit, but I cannot figure out how to remove it? Can you help me?

asked by: Gregg

0

Expert Reply:

To remove the iRV RV Stereo - Single DIN part # 292-101809 you will need to remove the snap on end cap on each side. Behind these you will find the two mounting screws on each side which can be removed giving you the access you need behind the stereo.

A trim panel tool kit can help with this like the Powerbuilt Trim Pad Remover part # ALL648544 can make this an easier job if you don't already have it.

expert reply by: Randy B

0

Answer 1

The iRV Wall Radio - iRV35 #292-101809 has trouble with the apps on many devices. It is the apps that are the issue based on the information provided on many forums. The pairing is an issue and they simply recommend standing very close to the unit…

view full answer...

Answer 2

The iRV Wall Radio #292-101809 has RCA audio output this will plug directly to the amplifier's input but you will need a separate power source to power the amplifier.

view full answer...

Answer 3

The Drive RV Stereo part #324-000031 has one zone with a max output of four speakers. Therefore, this would not be a good replacement for an iRV RV Stereo part iRV33. Furthermore, you would actually need a double din not a single din like the above.…

view full answer...

Answer 4

Roof vents with fans like the MaxxFan Roof Vent w/ 12V Fan #MA00-04000K do not have a fuse anywhere in the fan itself. You will want to use a circuit tester like #PTW2993 to see if there is power getting to the fan. If it was installed by the…

view full answer...

Answer 5

For the iRV stereo part #292-101809 the yellow wire runs to the vehicle battery, the red runs to a circuit that sees voltage only when the vehicle is turned on (think of this as the activation circuit to turn it on), blue runs typically to a power…

view full answer...

Answer 6

The manual for the iRV36 states to hold the power button for 5 seconds to reset the unit. Since you've already tried that I recommend pulling the unit from the wall and removing the fuse to cut the power to the unit. This will allow the unit to…

view full answer...

Answer 7

The iRV RV Stereo part #292-101809 is an excellent option with wireless remote, Bluetooth compatibility, AM/FM stereo, and AUX ports. It can read and play CD's and DVD's but not BluRay. There are no RV stereos which play BluRay.

view full answer...

Answer 8

If power is not actually making it to the rear jack on your trailer's leveling system, then I recommend inspecting the wiring along with making sure the battery you're using is fully charged. Visually inspect the wiring to make sure there…

view full answer...

Answer 9

For your electric jack, there are only three possible explanations for your jack not working with a charged battery. Either power is not getting to your motor, your motor is bad, or your ground connection isn't working properly. To test power,…

view full answer...

Answer 10

Yes, we can ship the Space Dock 2" Receiver Adapter for Torklift Palomino Landing Pad Bumper part #TLA7900 to you in Canada! However, the quoted shipping costs does not include all brokerage fees and duties. Taxes are not included and all prices…

view full answer...

Answer 11

If your 2021 Rockwood Freedom has a GoPower plug already installed, then all you'll need is the Go Power Portable Solar System with Digital Solar Controller - 90 Watt Solar Panel #34282729 you were looking at. There won't be any additional…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Removal of the iRV RV Stereo part # 292-101809

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching