How are Spacers Used When Installing Cam-Action Lockable Door Latch Kit # PLR458-018
Question:
I purchased this kit PLR458-018, but have not been able to figure how to install the spacers. How are the spacers attached? Are they also welded onto the pipe?
asked by: Paul
0
Expert Reply:
I attached a picture that shows the spacers lined up on the cam door latch # PLR458-018 to show you where they install. They basically install in between the top and bottom bar clamps and the latch system on top. This is designed to prevent the bar from sliding down when it's not latched. I've used these before and they have a tendency to slip down if they don't have the spacers holding them in place.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Cam-Action Lockable Door Latch for Large Enclosed Trailers - 2 Point - Zinc-Plated Steel
- Trailer Door Latch
- Latches
- Cam Door Latch
- Lock Not Included
- 5-1/8 Inch Long
- 2 Inch Wide
- Polar Hardware
more information >
Continue Researching
- Q&A: What Are the Torque Specs for Trailer Suspension Parts
- Shop: Cam-Action Lockable Door Latch for Large Enclosed Trailers - 2 Point - Zinc-Plated Steel
- Shop: Glolight LED Combination Tail Light for Trailers under 80" Wide - Square - Red - Driver Side
- Video: Review of Polar Hardware Enclosed Trailer Parts - Doors - PLR458-018
- Q&A: What Size Wrench/Socket Needed to Torque Nut of Convert a Ball part # 906B
- Video: Convert-A-Ball Interchangeable Ball Set Review
- Shop: BOLT brand vehicle and hitch locks
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Trailer Hitch
- Search Results: locking hitch pin
- Search Results: hitch lock 3 1 2
- Search Results: cam action
- Search Results: cam door latch
- Search Results: cam latch
- Search Results: trailer door bar lock
- Search Results: hitch lock
- Shop: Convert-A-Ball Interchangeable Ball Set - 3 Balls - 1" XL Shank - Nickel
- Shop: Hollywood Racks Hitch Lock for 2" Hitches
- Shop: Hollywood Racks Threaded Hitch Lock for 2" Hitches
- Shop: Cushioned Ball Mount for 2" Hitches - 4-3/4" Rise - 6" Drop - 10,000 lbs
- Shop: Convert-A-Ball Interchangeable Ball Set - 2" and 2-5/16" Balls - 1" Shank - Stainless
- Q&A: Mounting Bracket Options for Optronics Sealed, Thin Line Clearance Side Marker Light # MC65AB
- Q&A: Are Replacement Handle Grips for the Polar Cam-Action Door Latch Available for Replacement?
- Video: Polar Hardware Lock Side-Door Bar Lock Assembly Review and Installation
- Video: Polar Hardware Enclosed Trailer Parts 158-100 Review
- Video: Optronics Sealed Thin Line LED Trailer Clearance Light Installation MCL75RB
- Video: Review of Polar Hardware - Enclosed Trailer Parts - PLR158-202
- Video: Review of etrailer Trailer Fenders - Single Axle Fender - HP49FR
- Q&A: Recommended Handle Latch Kit for Barn Door on Dump Trailer