Troubleshooting 5th Wheel Landing Gear That's Blowing Fuse
Question:
My landing gear fuse keeps popping and so I believe I have a short some where. I have replaced the motor and switch and it still is popping the fuse. Any suggestions that might be causing it?
asked by: Bill M
Helpful Expert Reply:
There a couple of additional things you can check out. Take a good close look at the wiring, especially at pinch points and areas where the wiring might pass through a frame member or bulkhead. Cracks or worn spots in the wire insulation can allow the copper conductor to short out on the trailer frame and cause the fuse to blow. Also, disconnect the motor and try the landing gear manually. If it works manually, there's a wiring problem somewhere. If it won't, there's a mechanical problem internally with the gears that's most often caused when the gear is accidentally over extended or retracted. If it binds up when you try to crank it manually, disconnect the linkage between the two and try each leg individually to find the one that's bound up. Depending on the manufacturer and model, we might be able to get you a replacement lead or follow leg if you need it.
Give the things I mentioned above a try, if you would and let me know how it works out.
Product Page this Question was Asked From
Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Continue Researching
- Shop: Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Shop: Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Q&A: Recommended Replacement For A Dometic RM1350 RV Refrigerator
- Shop: Everchill RV Refrigerator w/ Freezer Drawer - French Doors - 16 cu ft - 12V - Stainless Steel
- Video: Stromberg Carlson Trailer Jack LG-142178 Review
- Search Results: e226168
- Search Results: 1rv~200
- Search Results: landing gear motor
- Q&A: Replacement Motor Recommendation for a Jack ADTH 1RV-200 on a 2006 Keystone Raptor 37
- Q&A: High-Capacity Stromberg Carlson Landing Gear Motor LG-196308 Blows Fuses
- Q&A: Keystone Raptor Fifth Wheel Trailer Landing Gear Motor Replacement
- Q&A: How To Choose the Correct Replacement Landing Gear Motor
- Q&A: Replacement Motor Options for Stromberg Carlson Electric Landing Gear Set
- Q&A: Troubleshooting Trailer Landing Gear Motor that Skips/Clicks when Activated
- Shop: Lippert Standard 5th-Wheel Landing Gear Motor w/ IP Rated Switch and Harness
- Shop: Replacement Switch for Stromberg Carlson Electric Landing Gear
- Shop: Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs
- Shop: Replacement Motor with Clutch for Lippert Ground Control 2.0 Electric Leveling System
- Search Results: best 5th wheel tpms
- Search Results: replacement jack motor
- Search Results: 5th wheel landing gear
- Video: Review of etrailer RV Parts and Accessories - Spring-Loaded Pull Pin - RVLG-SPP
- Video: Lippert Components Trailer Jack LC144214 Review
- Search Results: lg~196308
- Shop: Fifth Wheel Hitch
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Video: Choosing the Right Brake Controller
- Article: How to Choose the Right Trailer Hitch Class