High-Capacity Stromberg Carlson Landing Gear Motor LG-196308 Blows Fuses
Question:
Hi, I recently replaced the Venture gear box and the landing gear motor on my fifth wheel. I had the clunk-clunk noise and no movement of the legs, so I got a new metal gear box, and since its a big toyhauler, upgraded the motor to the Stromberg Carlson LG-196308, higher rpm and heavier rating. All legs turned easily by hand, and I synchronized legs, regreases everything and the gears for the legs looked great. Hooked everything up correctly, however when I go to extend the legs, the fuse pops. Retracts fine. Help?!?!!??
asked by: Curt S
Expert Reply:
It sounds like the new higher-capacity Stromberg Carlson motor # LG-196308 you're using is drawing more power than your old motor did. It is likely that your wire gauge and/or fuse value are inadequate for the extra current drawn by the higher-rated motor.
Stromberg-Carlson recommends no smaller than 10-gauge wiring for this motor, and then only for runs up to about 12-feet. If your wiring is smaller gauge than this then you'll want to use 10-gauge wire like # 10-1-1. If this does not correct the issue then you may also need a larger fuse than your old motor did.
Products Referenced in This Question
Product Page this Question was Asked From
Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Continue Researching
- Search Results: landing gear motor
- Article: Best Landing Gear
- Search Results: rp500708
- Search Results: landing gear
- Shop: Performance Chip Tuners
- Shop: Nerf Bars - Running Boards
- Shop: Suspension Enhancement
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Video: etrailer Landing Gear Set Review
- Search Results: outdoor faucet
- Video: Lippert JTs Strong Arm 5th Wheel RV Jack Stabilizer Kit Review
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Q&A: How to Adjust the Height of a 5th Wheel Trailer Pin Box
- Shop: Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies
- Shop: Lippert Venture 5th Wheel RV Landing Gear Motor
- Shop: Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Shop: Westin E-Series Round Nerf Bars - 3" - Polished Stainless Steel
- Shop: Aries Round Nerf Bars - 3" Diameter - Black Powder Coated Steel
- Video: MORryde 5th Wheel Cross Brace Landing Gear Stabilizer Installation - 2018 Jayco Eagle Fifth Wheel
- Q&A: How to Find Correct Replacement Landing Gear Set
- Q&A: Bracket Dimensions of the etrailer RV Landing Gear System # RVLG-8HDL
- Q&A: Replacement Landing Gear with 29-1/2 Inch Legs
- Q&A: Replacement 29-1/2 Inch Tall Landing Gear Follow Leg
- Q&A: Replacement Landing Gear Legs for RV that are 29-1/2 inch Measured Outer Tubes
- Shop: Fifth Wheel Hitch
- Search Results: 5th wheel jacks
- Search Results: 5th wheel landing gear
- Q&A: How To Determine Fit of the Landing Gear Set RVLG-8000
- Search Results: atwood landing gear motor
- Video: Stromberg Carlson Trailer Jack LG-142178 Review