Is There a Difference Between Furrion Vented Range Hood # FHO23SACRBL and FH235ACR-BL

Question

Question:

What is the difference between this model FHO23SACR-BL and The model FH235ACR-BL

asked by: Brandon

0

Expert Reply:

The only reference to the second part number you mentioned I was able to find online was on an Australian auction site but judging from the appearance of the unit in pictures it appears to be the exact same thing as the Furrion Vented Range Hood # FHO23SACRBL that you referenced.

I attached a review video for these for you to check out as well.

expert reply by: Jameson C

0

Answer 1

Yes, the Greystone Built-in Microwave part #324-000105 replaces microwave model P90D23AP-X3-FR03 confirmed by Greystone. They do not sell this particular microwave without the trim so the replacement 324-000105 does come with the trim piece as well.…

view full answer...

Answer 2

I looked up the dimensions of your Sylvania Microwave SR-11092B (12-1/4" tall x 20" wide x 13" deep) and compared them to that of the Greystone Microwave part #324-000105 (12" tall x 19" wide x 14-5/8" deep). I believe…

view full answer...

Answer 3

The best replacement we have for the Sylvania Microwave SR-11092B is going to be the Greystone Microwave part #324-000105. This microwave comes with its own frame that will need to be used but it should cover your cut out so you will never be able to…

view full answer...

Answer 4

The Ventline S0721 Series RV Range Hood w/ Light - 12V Fan - No Damper - 12x24 - Smooth White #S0721-24WD-F-1 utilizes the Replacement 12-Volt DC Fan Motor for Ventline RV Range Hood #BVD0218-00-R which has specs of 12v and 5 amps maximum. That…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 7

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 8

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 9

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 10

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…

view full answer...