SumoSprings Suspension Kit Recommendation for 2019 Fleetwood Bounder 35k

Question

Question:

Which set of SumoSprings do I need for my 2016 Fleetwood Bounder 35K?

asked by: Larry

0

Expert Reply:

I did some research on your 2019 Fleetwood Bounder 35k and since it has a 22,000 lb GVWR the best SumoSpring solution we have for it is the Maxim Springs part # SSR-187-54-1. This will give you an additional 5,400 lbs of suspension support and also help with stability as well.

I attached an install video for this kit on a similar 2019 F-53 motorhome as yours as well.

expert reply by: Jameson C

0

Answer 1

The recommended SumoSprings for your 2015 Fleetwood Bounder 35K, which was built on a Ford F-53 chassis, are the SumoSprings Maxim Custom Helper Springs - Rear Axle #SSR-187-54-1 and the SumoSprings Rebel Custom Helper Springs - 2 Piece - Front Axle…

view full answer...

Answer 2

Your Fleetwood Bounder 35K features a GCWR of 26,000 pounds so for the rear axle the SumoSprings Maxim Custom Helper Springs #SSR-187-54-1 will work perfectly to upgrade the rear suspension and stabilize the Ford F-53 chassis during travel. These…

view full answer...

Answer 3

The SumoSprings I recommend for your motorhome built on a 2019 Ford F-53 chassis with a 24,000 lb GVWR are the SumoSprings Maxim Custom Helper Springs - Rear Axle #SSR-187-54-1 and the SumoSprings Rebel Custom Helper Springs - Front Axle…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

There is a suspension enhancement option for your 2021 Entegra Vision XL built on a Ford F-53 chassis, but I verified with the manufacturer that the steering stabilizer only fits if you have at least a 24,000 lb GVWR. You're not out of luck…

view full answer...

Answer 7

The correct SumoSprings kit for your 2014 Itasca Sunstar 35F is the part #SSR-180-54-1 for the rear and part #SSF-170-40-2 for the front.

view full answer...

Answer 8

Hey Ron, thanks for reaching out! We have two different steering stabilizers for your motorhome on a 2018 Ford F-53 chassis; the Roadmaster Reflex and the Roadmaster Exact Center. The Exact Center was supposed to be an upgrade to the Reflex but after…

view full answer...

Answer 9

To replace/upgrade the bushings on the rear factory sway bar of your 2009 Class A Newmar Canyon Star RV you need one of the following Roadmaster kits based on the diameter of your factory sway bar: - 1-3/8" Diameter #RM-4139-300 - 1-1/2"…

view full answer...

Answer 10

Yes, there are SumoSprings that fit your 2021 Ford E-450 cutaway chassis, and what you need is the following: - SumoSprings Solo Custom Helper Springs - Rear Axle #SSR-130-54

view full answer...

Answer 11

To flat tow your 2021 Jeep Wrangler Unlimited 4Xe Rubicon Hybrid you will need a tow bar, base plate, tow bar wiring kit, braking system, and safety cables. I have the following recommendations for you listed below: Tow Bar: Roadmaster Nighthawk All…

view full answer...

Answer 12

Between the two part numbers #SSR-130-54 and #SSR-130-47 the key difference is the amount of support each will provide for your 2021 Ford E-450 Class C motorhome. The 47 provides 1,500 lbs of additional support whereas the 54 provides 2,800 lbs. To…

view full answer...