Does the CE Smith Trailer Fender Have Two Rounded Edges

Question

Question:

Are the edges on both sides of this fender rounded/radius? or does one side have a flat/straight 90° mounting surface? Im looking for an aluminum diamond plate fender that is 6-8wide with matching radius on both sides, no flat mounting surface.

asked by: Jeff

0

Expert Reply:

The CE Smith Single-Axle Trailer Fender # CE17701ATB that you referenced has rounded edges on both sides of the fender. Check out the picture I attached that shows that both sides of the fender have rounded edges.

You may also be interested in purchasing CE Smith Trailer Fender Brackets # CE26061G-2.

expert reply by: Jameson C

0

click to enlarge

Answer 1

In order to find the correct replacement fender for a trailer you'll need to know the wheel size. The CE Smith Single Axle Trailer Fender part #CE17960ATB seems to be a goof match but it's for 13" wheels. If this is not the size you have…

view full answer...

Answer 2

For 13 inch trailer wheels we have the Single Axle Trailer Fender with Backing part #HP79VR which would be a great option. Here are the dimensions for you to compare to your trailer. 7-3/4" Wide x 28" long x 10" tall.

view full answer...

Answer 3

To mount trailer fender #HP66VR you can use L-brackets #CE26061G-2. I included a picture that shows an example installation for you. The fender could also be welded on by a professional welder.

view full answer...

Answer 4

I went out to the warehouse and measured the Mounting Brackets item #CE26061G-2 you referenced. The bolt hole spacing on the side with two holes is 3-1/2". The diameter of the bolt holes is 3/8". I have linked a diagram I made below.

view full answer...

Answer 5

We do carry plastic, steel and aluminum replacement trailer fenders as well as various fender mounting brackets but these are not trailer-specific items. We have no way to look up parts such as fender brackets that were used in fabrication of any…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 10

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Does the CE Smith Trailer Fender Have Two Rounded Edges

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching