Troubleshooting Trailer Wiring Install Where Blinkers Activate Both Sides of Trailer
Question:
Hello, I recently purchased from etrailer, 277-000143 Epicord 7-Way Molded Trailer Plug - 8foot Long, to replace the cord on my Hurst trailer. My trailer has actually 6 wires: white, black, red, yellow, brown, and green. It does not have a blue wire, but it does have brakes. I followed the wiring diagram on your website. but after finishing all my connections, only my running lights work. when I turn the signal lights on my truck, both signal lights come on trailer acting as blinkers. and this happens on either the right or left signals are on the truck. I have tested to make sure I have power coming from truck. I would greatly appreciate any kind of insight you could offer me. Seems like Ive tried everything. Have a great day!
asked by: Julio A
Expert Reply:
Sounds like you might have swapped the turn signal circuits and the running light circuit on your trailer wiring. This would cause both of the blinkers to flash when you put on either blinker. So what I would recommend you do is start over with the wiring connects. Use a jumper wire from a 12 volt battery positive post to run voltage to each of the trailer wiring circuits so that you can identify what all of the circuits are. And then use the diagram you found already to make the connections to the correct circuits.
Product Page this Question was Asked From
Epicord 7-Way Molded Trailer Plug - 8' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 6 - 10 Feet Long
- Plug and Lead
- 7 Round - Blade
- Epicord
more information >
Continue Researching
- Shop: Epicord 7-Way Molded Trailer Plug - 8' Long
- Search Results: amber marker lights
- Search Results: 7 way harness
- Search Results: 7 way trailer plug
- Search Results: breakaway kit
- Q&A: How do LED Sidemarker Lights Wire in to Trailer Light Wiring
- Q&A: Adding a 4- and 7-Way Trailer Connector to a 2017 Jeep Cherokee Trailhawk
- Shop: Curt Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Side Load
- Shop: Optronics LED Trailer Clearance and Side Marker Light w/ Reflex Reflector - 6 Diodes - Amber Lens
- Shop: Pollak Trailer Connector Adapter - 7-Blade Plug to 7-Pole Round Pin - Nylon
- Shop: LED Trailer Clearance or Side Marker Light - Submersible - 5 Diodes - Round - Amber Lens
- Shop: Tow Ready Replacement 7-Way Harness and Socket for Factory Tow Package
- Shop: Timbren Axle-Less Trailer Suspension w Electric Brakes - Standard Duty - No Drop - 5 on 4-1/2 - 3.5K
- Video: Bargman Wiring - Trailer Connectors - 50-67-106 Review
- Search Results: bargman
- Shop: Trailer Wiring
- Video: Choosing the Right Trailer Wiring
- Search Results: junction box
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Video: Hopkins Trailer Breakaway Kit Review
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 25580
- Video: Choosing the Right Brake Controller
- Shop: Brake Controller
- Q&A: Recommended Dexter Suspension Kit 7753400
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Gooseneck Hitch