Can Edge Gas Evolution CS2 Tuner Adjust Torque Management on 2018 Chevy Silverado 1500

Question

Question:

Will this adjust tq management on a 6.2 8 speed 2018 Silverado ?

asked by: Brent

0

Expert Reply:

I reached out to my contact at Edge and he did first say that the correct Gas Evolution CS2 Performance Tuner for your 2018 Chevy Silverado with the 6.2L engine is the part # EP25350. He said when installed it will automatically adjust/reduce the torque management but it's not going to let you completely get rid of it. You won't be able to manually adjust this.

The Evolution CS2 will however let you completely disable the Silverado's Active Fuel Management. I have included the full install manual below that you can also check out.

expert reply by: Chris R

0

Answer 1

I would be happy to help! There is a few options to get the increased clearance you need to raise your trailer so you can stow away your jack when not in use. I recommend replacing the coupler with a standard a-frame coupler you would still be able…

view full answer...

Answer 2

I have a solution for you. We do not carry hardware kits for the Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K #DM37ZR. However the instructions will give you the dimensions you will need and you can…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is…

view full answer...

Answer 6

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...