Length and Angle of JR Products Hook and Keeper for Enclosed Trailer # 37211755

Question

Question:

Is this a four inch hasp or six inch 45 degrees. I need a si,45degreees

asked by: Jeff J

0

Expert Reply:

The JR Products Hook and Keeper for Enclosed Trailer # 37211755 is a 6 inch long 45 degree hook and keeper like you are looking for.

expert reply by: Jameson C

0

Answer 1

This is exactly what you're looking for. The JR Products Hook and Keeper #37211755 is 6" and is set at a 45 degree angle.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 8

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 9

The 171255UC seal has an inner diameter of 1.719" and an outer diameter of 2.565". I was unable to find an oil seal that matches these measurements, but we do have the Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for…

view full answer...

Answer 10

A shorter hook would help with the angle of the door to help get the hook into the holder for your trailer's door. An option with a 45 degree bend in it, like the part #37211765, would give you a better option to work with the angle of the door,…

view full answer...

Answer 11

It is very unusual for 4-pole trailer wiring to get hot enough to melt the 4-pole plug. This wiring format carries only basic lighting signals, no trailer brake power, no reverse lights and no auxiliary 12V power. It would be much more common for an…

view full answer...

Answer 12

While doing on research on this product I contacted the manufacturer that assembles this product. They confirmed that yes, the Shim for Narrow Bracket Strap Hinge Stainless Steel #PLR2001-SS will work. It adds 1/8" shim for the 36" Lock…

view full answer...