Can Gen-Y Aluminum Loading Ramps # 325-GH-R96 Be Used to Span Dip for Backing Up Camper
Question:
I am needing a set of ramps to span a dip in front of my building. I will be backing a 25’ camper in and now the skid plates bottom out. Would these types of ramps work laying flat across the ? I have a 2008 Chevy Silverado 2500 that would also need to be supported. The 2 vehicles will not be on the ramps at the same time. Do you think I would need an arched set rather than flat.
asked by: Don L
Expert Reply:
As long as they provide the needed length and track width, the Gen-Y Hitch Aluminum Loading Ramp Set # 325-GH-R96 that you referenced will work great for your application. They provide plenty of strength (10,000 pound capacity for the pair - which represents the highest rated set we have available) and their angled base will allow you to maintain an ideal loading angle for the camper and your Silverado.
A flat set like this will work well to avoid dragging the skid plates on the trailer as you traverse over that dip.
The ramps measure 96 inches long and 15 inches wide. I have attached a short video demonstration that you can check out as well.
Product Page this Question was Asked From
Gen-Y Hitch Aluminum Loading Ramp Set - 8' Long x 15" Wide - 10,000 lbs
- Car Ramps
- Loading Ramps
- Open Trailer
- 15 Inch Wide
- 96 Inch Long
- Car Hauler Ramps
- 10000 lbs
- Gen-Y Hitch
more information >
Continue Researching
- Shop: Gen-Y Hitch Aluminum Loading Ramp Set - 14' Long x 15" Wide - 8,000 lbs
- Shop: Gen-Y Hitch Aluminum Loading Ramp Set - 10' Long x 15" Wide - 14,000 lbs
- Shop: Race Ramps Trailer Loading Assist Ramps - 8" Lift - 74" Long - Qty 2
- Shop: Race Ramps Trailer Loading Assist Ramps - 8" Lift - 95" Long - Qty 2
- Shop: Gen-Y Hitch Aluminum Loading Ramp Set - 7' Long x 14" Wide - 6,000 lbs
- Shop: Race Ramps Trailer Loading Assist Ramps - 6-1/4" Lift - 74" Long - Qty 2
- Shop: Race Ramps Trailer Loading Assist Ramps - 8" Lift - 54-3/4" Long - Qty 2
- Q&A: Ramp Weights of Gen-Y Hitch Aluminum Loading Ramp Set part # GH54FR
- Q&A: Gen-Y Aluminum Ramp Set-96 long X 15 Wide-10,000 lbs Material and Wall Thickness
- Q&A: Ramp Recommendation for Loading Bobcat 331 Onto Trailer
- Video: Race Ramps Trailer Loading Assist Ramps Review
- Search Results: e track
- Search Results: aluminum e track
- Search Results: l track
- Search Results: trailer camera systems
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Search Results: 44649
- Shop: Trailer Hitch
- Video: etrailer Horizontal E-Track Review
- Article: 5 Things to Know About Weight Distribution Hitches
- Search Results: e~track
- Shop: Trailer Wiring
- Article: Trailer Wiring Diagrams
- Video: B&W Continuum Weight Distribution System Review
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Video: Review of Reese Weight Distribution - WD Only - RE44FR
- Shop: Brake Controller
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: 68149
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)