Weld-On Pipe Mount Pin Hole Diameter

Question

Question:

What diameter is the thru hole for the pin on the pipe mount pn DL22670?

asked by: Mark

0

Expert Reply:

The diameter of the pin hole for the weld on pipe mount, item # DL22670, is 1/2 inch.

expert reply by: Amanda

0

Answer 1

We do carry the Bulldog Square Jack #BD195354 which is mounted on your trailer.

view full answer...

Answer 2

The overall length of the #DL22670 that you referenced is 1-7/8 inches long. For a similar pipe mount that is 2-1/4 inches long and 2 inches in outer diameter we have the part #BD015279 which would be what you'd need.

view full answer...

Answer 3

I have confirmed with my contacts at Dutton-Lainson, and the correct mounting pipe for the Pipe Mount Swivel Style Jack #DL22685 is the Weld-On 2" Diameter Pipe Mount Tube for Pipe Mounted Trailer Jacks Item #DL22670. This mounting pipe is 1-7/8…

view full answer...

Answer 4

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Weld-On Pipe Mount Pin Hole Diameter

Product Page this Question was Asked From

Continue Researching