Will the Curt T-Connector or T-One Disable Park Sensor Warning on a 2016 Ram ProMaster City

Question

Question:

Will this wiring harness deactivate the packup sensors on the PMC? I plan on using a motorcycle carrier rather than a trailer and am looking to either put trailer lighting on the carrier or find some way to use the wiring harness to bypass the backup sensors. 2016 Ram Promaster City Tradesman SLT

asked by: Brian

0

Expert Reply:

The only trailer wiring harness I am aware of that disables the park sensor warning message on a Ram ProMaster City is the Mopar Trailer Tow Wiring Harness. The T-One Vehicle Wiring Harness part # 118719 and the Curt T-Connector Vehicle Wiring Harness part # C56270 will not disable the park sensor warning message so if you use either of these you may get an in-dash error message while in reverse with a trailer attached. This will not have an effect on anything but it can be rather annoying. That said, the park sensor warning feature may be able to be disabled permanently but you would need to reach out to the manufacturer to see if this is possible as I was not able to find anything about this online.

expert reply by: Conner L

0

Answer 1

For your 2021 Ram ProMaster City I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver #75219. This custom-fit hitch will be perfect for a bike rack and towing your trailer. It has a 2" receiver with a maximum gross trailer weight of 3,500…

view full answer...

Answer 2

There are a couple of differences between the wiring harnesses for your 2016 Ram ProMaster. The biggest difference is the technology used. The Curt #C56270 uses what is called Surface-Mount Technology. Essentially what this does is almost eliminate…

view full answer...

Answer 3

The Gear Space 34 Enclosed Cargo Carrier part #HGK826 is a slide out model so depending on your vehicle's rear doors you may have access to the rear cargo area. For example: the slide out feature does clear the hatchback on a 2014 Toyota Sienna…

view full answer...

Answer 4

I wouldn't be very happy if I just go a new damaged Yakima BackSwing, part #Y02483, either. The good news is that yours actually isn't. The BackSwing has an intentional bend in it that looks like a dent. Yakima designed it that way on purpose…

view full answer...

Answer 5

The Saris Swing Away Hitch Extender for Bike Racks part #SAR36VR will work on any vehicle with a 2" trailer hitch. It has a 250 lb weight capacity so as long as the weight of the scooter and carrier do not exceed this you'll be good to go.

view full answer...

Answer 6

The Curt Cam Buckle Stabilizing Strap #18050 is usually used on Class I or Class II hitches to help distribute the weight on them. Since your hitch #C13136 for your 2013 Ausi Q5 is a Class III hitch, then it does not need the stabilizing strap. If…

view full answer...

Answer 7

The Tekonsha T-One #118304 and Curt T-Connector #C55580 Vehicle Wiring Harnesses are very similar. These are both custom fit wiring harnesses that include a tail light converter, which is required for your 2007 Toyota Sienna because the brake and…

view full answer...

Answer 8

Thanks so much for your purchase, and I can tell you that the Curt Cam Buckle Stabilizing Strap #18050 is not a requirement for use with the Curt Trailer Hitch Receiver #C13206. While Curt does recommend the use of the strap, it is not needed in…

view full answer...

Answer 9

Although the Kuat Alpha has a 3 bike capacity, when it is used with a class I receiver such as the one on your Mazda, you should only place 2 bikes on it. This is not only due to the limited tongue weight capacity of the hitch, but also because of…

view full answer...

Answer 10

If the Curt T-Connector Vehicle Wiring Harness #C56270 on your 2015 Ram ProMaster City is sending those same signals whether your trailer is connected or you're using a circuit tester to check functions then it likely means the Curt wiring is bad…

view full answer...

Answer 11

It looks like on a 2005 Chrysler PT Cruiser convertible, you will have to place the hook on the strap #18050 in the gap between the body of the car and top of the trunk. You may have to open the trunk to get the hook in place and then close the…

view full answer...

Answer 12

We'd be happy to help you out with that! We'd recommend the Tekonsha #118719 4-pole taillight converter/wiring harness for your 2020 Ram ProMaster City. The harness/connector will provide basic lighting functions for your non-braked trailer.…

view full answer...

Will the Curt T-Connector or T-One Disable Park Sensor Warning on a 2016 Ram ProMaster City

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching