Replacement 15 Wheel for 1979 Camper with Large 4-Bolt Pattern

Question

Question:

Where can I find a 15 inch camper Rim like the one I have in this picture its on a 1979 fan

asked by: Donald E

0

Expert Reply:

From the picture you sent in it looks like the Dexstar Vintage Steel Wheel # AM20395 15" x 5" is what you are looking for. These have a 4 on 9.44" bolt pattern which you can verify matches what you have by measuring from the center of one bolt hole to the center of the bolt hole directly across from it. I have attached a photo for you to check out.

Please note that these wheels do have a +5 mm offset so you need to make sure that is compatible with your setup as well. Attached are videos of each wheel for you to reference.

expert reply by: Jon G

0

click to enlarge

Answer 1

I recommend going with the 5" Wheel #AM20395 and the ST205/75R15 #AM10245 tire.

view full answer...

Answer 2

Your ST205/75R15 tires will fit both the Dexstar Vintage Steel Wheel w/ +5 mm Offset - 15" x 5" Rim - 4 on 9.44 - Silver #AM20395. 205/75-15 tires will fit 5", 5-1/2", 6", and 6-1/2" rim widths.…

view full answer...

Answer 3

It sounds like the wheel on your 1972 Prowler travel trailer is a hub centric wheel that is secured to the hub with a wheel bolt like the flat head wheel bolt, #090753. A hub centric wheel centers on the raised portion of the hub that you mentioned…

view full answer...

Answer 4

The only Dexstar wheels we carry are not available as part of a tire and wheel combo, unfortunately. We do have the Dexstar Vintage Steel Wheel w/ +5 mm Offset - 15" x 5" Rim - Silver #AM20395. These wheels have a bolt pattern of 4…

view full answer...

Answer 5

We offer four vintage-style trailer wheels with the 4-on-9.44-inch bolt pattern that can be seen on the linked page. These wheels are available in 13-, 14- and 15-inch diameters. Note that all four of these wheels have a 5mm positive offset, meaning…

view full answer...

Answer 6

The Dexstar Vintage Steel Wheel part #AM20395 is sold individually. If you need all four wheels then you'd have to order a quantity of four.

view full answer...

Answer 7

Yes, the Typical Axle Diameters Based on Axle Capacity are as follows: 1,000-lb - 2,000-lb Axles: 1-1/2 inch - 1-3/4 inch diameter 3,500-lb Axles: 2-3/8 inch diameter 5,200-lb - 7,200-lb Axles: 3 inch diameter If you have a 3" diameter axle then…

view full answer...

Answer 8

When the L68149 bearing is paired with the L68111 race, the 10-19 grease seal is used. However when the same bearing is used with the L68110 race on a boat trailer, the #168233 seal is usually used. You can verify this by using a digital caliper to…

view full answer...

Answer 9

Glad we were able to help! And that you got the correct Seal #L68110 and Seal #168233.

view full answer...

Answer 10

The Lippert Components Heavy-Duty Replacement Shock - Yellow #LC283280 is 8.625 inches compressed and 13.5 inches fully extended. Your current suspension may extend and retract slightly further but the shocks will be a good replacement based on the…

view full answer...

Answer 11

The difference between the L44649 and the L44649R is not the size of the race used as you have found. Typically the R indicates that the bearing was used in a higher capacity application. Dimensionally the bearings are the same and would take the…

view full answer...

Answer 12

Having a 1.25 spindle, it can be a few bearings that will fit. However, there will not be a hub that uses both an inner and outer bearing of this size. With that said, I highly recommend replacing your axles with something that will use a more common…

view full answer...

Replacement 15 Wheel for 1979 Camper with Large 4-Bolt Pattern

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching