Spare Wheel and Tire For a 1969 Frolic Camper with 15 Wheel and 4 on 9.44 Bolt Pattern

Question

Question:

A long shot but figured Id check before I guessed. We bought a 69 Frolic Camper last year and Im looking for a spare to have on hand. I know its a 15 494 rim but is there any way to look up the width? Im thinking Ill grab the 5 since its just a spare. Any insight is appreciated. Thanks

asked by: Adam M

0

Expert Reply:

I recommend going with the 5" Wheel # AM20395 and the ST205/75R15 # AM10245 tire.

expert reply by: Bud M

0

Answer 1

Your ST205/75R15 tires will fit both the Dexstar Vintage Steel Wheel w/ +5 mm Offset - 15" x 5" Rim - 4 on 9.44 - Silver #AM20395. 205/75-15 tires will fit 5", 5-1/2", 6", and 6-1/2" rim widths. If you also need tires,…

view full answer...

Answer 2

From the picture you sent in it looks like the Dexstar Vintage Steel Wheel #AM20395 15" x 5" is what you are looking for. These have a 4 on 9.44" bolt pattern which you can verify matches what you have by measuring from the center of…

view full answer...

Answer 3

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 6

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Spare Wheel and Tire For a 1969 Frolic Camper with 15 Wheel and 4 on 9.44 Bolt Pattern

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching