Recommended Fans for Use In Horse Trailer

Question

Question:

Solar panel air vents for his trailer. I have an old two horse trailer made of steel. I’m looking to put in two solor fans to remove the heat. What types of fans should I be using and what equipment will I need to install them

asked by: Tony N

0

Expert Reply:

I do have an option for you but the only solar powered fan we offer is the Ultra-Fab Solar-Powered Plumbing Vent part # UF53-945001 and this would not move much air in your horse trailer. The same can be said for most solar powered fans of its kind as they are really not designed to move large quantities of air. Therefore, a much better option for you would be to install a few 12 volt powered vent fans. I recommend the MaxxAir Mini Deluxe Trailer Roof Vent part # MA00-03851 or part # MA00-03801 which will put out about 10 times more airflow than the above solar powered option. The 12 volt power source would also not be dependent on weather.

In order to install the above 12 volt powered vent fan you would need to obtain an auxiliary 12 volt battery and some miscellaneous wire and wiring connectors. You will also need some roof sealant part # 0160297.

expert reply by: Conner L

0

Answer 1

We have the Ultra-Fab Solar-Powered Plumbing Vent for Motor Homes - 7" Diameter x 3-3/4" Tall #UF53-945001 which is designed to be mounted on the roof. My recommendation is to use this roof vent and allow your side vents to stay as they…

view full answer...

Answer 2

All you need is a dedicated 12 volt power source to run the MaxxFan Deluxe Roof Vent #MA00-07500K. So you can run this off the 12 volt battery powered by a solar panel, as it has just a power and ground wire. The other thing you will need for install…

view full answer...

Answer 3

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 4

Hey Dave, yes the High Pointe Convection Microwave our part number #HP99ZR is the exact same as the part number you are looking for so this would be exactly what you are looking for as a replacement.

view full answer...

Answer 5

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 6

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 7

With the information I have, the Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners #AT3308046006 could be a protentional replacement for your Dometic Quick Cool Ducted Air Conditioner, however, if you're able to…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 10

I do have a solution, but since Lance has their own plug design there are no adapters that will work, including the #47595. The best option is to replace the lance plug with a standard 7-way blade connector like the #PK12706. This will eliminate the…

view full answer...

Answer 11

Yes indeed. Adding some suspension enhancement helper springs such as #SSR-187-54-1 to your 2017 Fleetwood Bounder on the Ford F-53 chassis will make it even more stable. They will help with body roll which is what happens when wind gusts blow…

view full answer...

Answer 12

The diameter of your trailer axle will determine the size of the parts that you will need to order for an axle over under kit. If your axle is 3 inches diameter, the Dexter Trailer Springs Over-Under Conversion Kit, #K71-385-00, would be a great…

view full answer...

Recommended Fans for Use In Horse Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching