Trailer Hitch Fit for a 2010 Audi A4 Wagon

Question

Question:

Does this fit on the A4 wagon as well as the sedan?

asked by: Patrick W

0

Expert Reply:

The EcoHitch Hidden Trailer Hitch Receiver # 306-X7389 is only a fit for the Sedan model of the 2010 Audi A4. Since you have an Avant Wagon you need the Curt Trailer Hitch Receiver # C11195 instead as this is the only trailer hitch that is confirmed to fit your model.

Attached are the installation instructions for you to check out. If you let me know what you plan on using the trailer hitch for I'd be happy to make additional recommendations as necessary.

expert reply by: Jon G

0

Answer 1

We do have a receiver that will fit your 2008 Audi A4 2.0T Quattro with the dual exhaust, as the EcoHitch Hidden Trailer Hitch Receiver #306-X7389 has been confirmed by EcoHitch not to work with the dual exhaust. The Curt Trailer Hitch Receiver…

view full answer...

Answer 2

The hitch opening of the EcoHitch part #306-X7389 that you referenced is going to fit right under the rear bumper of your 2009 Audi A4 so the amount of ground clearance you'll lose will be right at 2-1/2 inches down the center of the vehicle. The…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 9

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Trailer Hitch Fit for a 2010 Audi A4 Wagon

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching