Bearing Buddy Bearing Protectors for 2.42-2.43 Inch Hub Bore

Question

Question:

I am getting 2.42-2.43 digital caliper measurement on hub ID - assume the 2441 is the most likely correct fit?

asked by: Bill R

0

Expert Reply:

Yes, based on the measurements you took of your hub bore diameter the correct Bearing Buddy Bearing Protectors is the part # BB2441 or # BB2441T-SS for the stainless steel model that will resist any corrosion. These are designed to fit hub bore diameters of 2.441 inches to allow for easy maintenance while also keeping dirt and water out of the hub.

I have attached a short video review that you can check out as well.

expert reply by: Chris R

0

Answer 1

Actually all you really have to do is remove the oil from the hub and then pack the hubs with grease and then get the correct bearing buddy to match the threaded hub bore. You will need to measure the inner diameter of where the old grease cap…

view full answer...

Answer 2

The Dexter 8-201 hub and drums use 12 x 2 inch brake assemblies. You can verify this by measuring your drums as shown in the attached picture. I recommend #AKEBRK-7-SA electric brake assemblies. Both the left and right hand brakes are included and…

view full answer...

Answer 3

My first thought would be blown fuses, so I would be sure to double check all fuses and relays related to the tow package. This information will be listed in your owner's manual. Check to ensure you are getting power at the trailer connector on…

view full answer...

Answer 4

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 5

The portion you need to measure is not the cap, but the the hub bore. Remove the grease caps and measure the diameter of the opening the caps occupy. This is the hub bore. You will need an accurate measuring devices like a set of dial calipers that…

view full answer...

Answer 6

The correct replacement breakaway cable kit for the Dexter brake actuator part #T63FR that you referenced is the part #DX76XR.

view full answer...

Answer 7

I do have an option for you but we don't offer any replacement brake pads for the Tie Down Engineering (TDE) 46304 Caliper as the company is no longer in business. Therefore, our only option to you would be a full replacement for which I…

view full answer...

Answer 8

Yes, the Timbken bearings part #TMK73VR and #TMK23VR are made in the USA.

view full answer...

Answer 9

When you use the Bearing Buddy Bearing Protectors like #BB2441, so you do not need to take apart the wheel hub and repack the bearings. The Bearing Buddy Protectors have a spring loaded seal that keeps the moisture and debris out of the bearings.…

view full answer...

Answer 10

Bearing Buddies like #BB2441 fit very tight into a trailer hub. In order to get them out, you will need to use a rubber mallet and persuade them out. Once the Bearing Buddy starts to unseat from the hub you can grab it and wiggle it out.

view full answer...

Answer 11

Replacement trailer bearings (and races and seals) are most easily identified by using the part numbers stamped or molded into the original parts. The linked photo shows the typical placement and appearance of these part numbers on bearings, races…

view full answer...

Answer 12

The best way to find the correct bearings, races, or seals for your trailer is to remove a wheel and hub and get the numbers off of the current components you have. If you are unable to fid the numbers on the bearings or seals or races, you can use a…

view full answer...