Availability of Replacement Bevel Gears for Happijac Trailer Jack

Question

Question:

looking for replacement parts for a 1998 8ft northstar pop up camper with happijac mechanical jacks

asked by: Randy B

0

Expert Reply:

What specifically are you looking for? The most commonly replaced component for a trailer jack is the bevel gears which the Replacement Bevel Gears # LC182851 you referenced are correct for that.

expert reply by: Jameson C

0

Answer 1

Good news! I was able to go out to the warehouse and measure the etrailer landing gear #RVLG-8HDL for you. I found that the distance between the weld stops from the outside to outside is 17-1/2 inches and from the inside to the inside of the weld…

view full answer...

Answer 2

I'd be happy to help you replace your landing gear! If you have a sticker to identify what you currently have I can see if we have a replacement for the one leg otherwise we'll need to get you a whole new set to make sure they operate at the…

view full answer...

Answer 3

It sounds like the landing gear on your Fuzion Toy Hauler may have been overextended, which likely caused damage to the internal gears and screw. This "flopping" that you mentioned is essentially the unit trying to extend but since the…

view full answer...

Answer 4

Thanks for the pictures! Based on the part number of your motor it appears you have Venture landing gear. As such you will likely need follow leg rebuild kit #LC146060 or lead leg rebuild kit #LC146059 to fix your landing gear. Landing gear legs are…

view full answer...

Answer 5

There will be a roll pin that runs through the bottom of the bevel gear you have on your Venture landing gear VMC900R that will need to be driven out before it can be removed. You would need to use a punch or a thin screwdriver to get it out.

view full answer...

Answer 6

I took a look in the owner's manual for the HappiJac Camper Jack 4600 and found the following under maintenance which I have attached for you below. Therefore, no, it's not advised to completely disassemble the jack to service the screw per…

view full answer...

Answer 7

If you are looking for a way to convert your landing to a dual motor setup there's really no way to do that without replacing the follow leg with a lead leg, adding a motor and gear box, adding an additional switch and eliminating the cross…

view full answer...

Answer 8

You might be able to get something like a center punch and tap it as much as possible at an angle. That could drive enough of it out the other side to be able to grab it with some pliers or vice grips. Another possible method would be to get a…

view full answer...

Answer 9

The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do…

view full answer...

Answer 10

If you have found metal shavings within the driver leg of your Atwood landing gear it does sound as though the unit may indeed have been damaged. The Cardinal 5th wheel RVs are manufactured by Forest River RV. I checked the specifications for the…

view full answer...

Answer 11

Atwood was sold to Dometic a few years back and replacement parts for older landing gear are scarce. We do still have Stromberg Carlson Landing Gear repair kit for the follow jack that will fit, part #LG-146060. For a lead jack repair kit use…

view full answer...

Answer 12

I do have an option for you but Atwood Landing Gear has been discontinued for several years and we don't offer confirmed replacement parts for them. Therefore, your best option would be to replace the entire set with an option like the Lippert…

view full answer...

Availability of Replacement Bevel Gears for Happijac Trailer Jack

Product Page this Question was Asked From

Continue Researching